Your NP205 should have 90 weight in it. I have never heard of mixing ATF with 90 weight. As one is fluid and the other is oil. I would think that...
Hi, you might have to move the motor mounts on the frame back, I did the same swap but I did not have any problems. But I swapped in a 1973...
Hi, as to your question, are you sure you have the torque convertor on the shaft all the way? there is no difference on the front side of 350 or...
Hi, did you replace the fuse in the fuse block? If so that only leaves the light switch itself. Hope this helps. Vince
RE: Dont know what they are called If you go to your dealer here is the part number for the "exhaust clamp" 3792519 Vince
Hi again, I got my other book and the number on the bellhousing mount is for a 1968 - 1969 327 used in Corvettes, Camaros and other high...
RE: Part number for temperature sen Hello, the GM # is 12334869 also on the box is G1852, give these numbers to your GM partsman or parts store...
Hi, the top and sides of the box sit behind the metal, and the bottom is sandwiched between the door hinge and the metal frame. In otherwords...
Hello your VIN is as follows: C- 2wd E- 8 cylinder 1- GVW-1/2 ton or (3900-5800) 4- pickup 9- 1969 Z-...
Did whoever put the engine in, pull the tranny or the speedo cable? Some GM trucks came with gear reducers attached between the speedometer cable...
Hi, parchment is most probably your seat color. As for carpet, if it had carpet there are only three colors listed in the chassis and body parts...
Hi, It is a spacer that goes between the deflector and the bearing on the back side of the spindle. It's been a long time, but there should be...
Hi, Yes I have seen it and it is very hard to find, but there is supposed to be one on each side. If you have a great partsman at your local...
The only thing with GM Transmissions is: Trannys for BOP {Buick,Olds,Pontiac} are set-up for starters on the driver side of the engine. All...
Hi, The main difference between the 1979 and 1980 to the 1981 -87 models besides sheetmetal is the bumper style and how they are mounted to the...
Hi, you also have to turn the switch to accessory with the key and pin to get it out. Vince
I would also check to make sure that the steering stabilizer (damper) is still good. That would affect it alot. vince
Also remember that you have to get a flywheel for the 400 or you will tear the engine apart. The 400 is an externally balanced engine, it is...
Hi. Yes you can do that. I have replaced them and have just pushed up with my legs and it works.
The part from GM isn't usually very expensive. You could try a transmission place. You will have to take the rear extension housing off.Get a...
Separate names with a comma.
