Two parts to this post: 1. Check out your local wrecking yard. I had the same problem, and one I found on ebay leaked beyond repair, also. I...
Good luck on the resto. If you decide you wanna throw in the towel, give me a shout - Snyder is my hometown and my dad is looking for a project!
I am looking for an exhaust manifold for my 235 if you have one available.
If I didn't know any better, I'd say that picture was taken near Abilene or Big Spring. Nice tall mesquite tree and clear west Texas sky. Am I...
Looking for some information on process and techniques for splitting the exhaust manifold on a 235 inline 6 for my '56 3200. Also, if anyone out...
Thanks for the insight. What I'm planning is probably far less thorough than most would do. I have machined aluminum blocks that will lift it 3"...
Not sure I understand what "bump steer" means? Without P/S, it can't get any harder than it is now, though. Got any recommendations?
It's been a while since I adjusted the valve lash, but I don't remember needing a torque wrench. Remove the valve cover, bring to operating temp...
I'm considering putting in a 4" lift kit on my '56 3200. Can anyone advise on whether or not I will need a new pitman arm? Any other linkage...
That's the missing piece - weld filling the holes. Of course, it would 't hurt to have the monster press you found, but it's a start. Thanks for...
Drilling out 6 holes where there are already 5 - sounds like a tricky deal. I can't use my Chevy drum, can I? It seems like there would be...
OK, folks, I'm looking for some knowledge. My 56 1/2 ton has the standard 3.93 rearend, which gives me about 3500 RPM doing 55 mph. I'm hoping...
Separate names with a comma.
