Remember way back 8-9 months ago? I had this miss in the 62' 235 motor that defied solution. It was a badly worn cam, worst case scenario,...
My 55' 235 motor has a 1/2" threaded hole for a water temp sender. Does anyone know a source for these. FLAPS doesn't have em'! Flashlight
1955 Chevrolet Muncie 3 speed with electric Overdrive. Solve all those issues about Rear-end gear swaps and tranny swaps. Here is the original GM...
1955 Muncie 3 speed with electric Overdrive. Clean unit came out of a professionally restored 1955 sedan. I have used the engine attached and it...
I had to swap my 235 (bad cam) out with another from a passenger car:(. My flywheel was bad so used the car flywheel, but with that, I needed to...
Both AD's are under control, just a few minor issue's on each, here's the 82' Wagoneer limited I pulled in today:eek:. So easy, all parts are...
I just about got the E-Brake finished on my 53'. It had a 55-57' open rear-end with no P-Brake parts in there. The 55-59' cables went in nice but...
:confused:I am going to replace the kingpins on my 53', I know I must replace both while I'm at it. The right side is dangerously loose, and the...
Help Please... I've put on three distributor caps, 2 distributors, numerous plugs, points and condensers and rotors, wires. I can remove the...
Here it is, 55' Chevy Sedan Blue Flame 235 with Borg Warner OD unit. I hope my 216 doesn't give up anytime soon because it will be hard to find...
:cool:Robert aka La troca This is what the 3 speed OD Muncie looks like. I'm told that when in OD, its like a 2.25 rear end:). Very sweet. This...
Hey guys, I've got one of these engine missing issues that defies solution:confused:. There seems to be a miss that's worse under power. Seems...
Thanks Fella's For the help over the last year. SWMBO finally got finished with the camera for important Facebook issues:eek:. So here goes,...
Ok, I read Wolf's post on just using a straight pipe and really liking the sound. He had a single manifold and later split the pipe to have a...
I'm am really tired of trying to get my original water temp gauge to work in my 47 with a 216:mad:. I've had the gauge rebuilt and new tubing...
:(Hey Guys, I am finally able to get back to work on my 53' as the temp got to 50 degrees today in the shop:eek:. I was able to scrape some...
Thanks Nate and Coilover on the Carb tuning advice for my dual carb set-up. I am completely inexperienced with dual's:o. I put a fenton dual...
I've been feverishly working on my 53' with a 235. I ended up putting on the Fenton Dual carb set-up with two Rochester "B's" on it. I also put a...
Did I make a $170 goof-up here? I bought some custom 235 ci stainless headers for my motor. I also got the Fenton dual carb intake. The bottom of...
I read a few threads on Carb Conversions. I saw where Nate preferred the Carter YF series Carbs. I am going to a dual Carb setup on a Fenton...
Separate names with a comma.
