The brown wire should be for the gen light, its actually the ground wire. When the alternator fails or when the motor is off but the key is on,...
Welcome to the Forum! The first thing I would recommend is to contact the fine folks at Chevy Duty and get a Factory Assembly Manual. It's got...
If you've altered the height of the truck you might want to adjust it a little. The angle should match the angle of the engine/tranny. If you...
I went through this in CA about a dozen years ago. I applied for an abandoned vehicle title (or something similar to that) and had to send a...
Here's a excellent place to get info on the hei distributor and alternator conversion. www.oldengine.org/unfaq/10si.htm...
Hey, On my truck the two bottom bolts on the tranny bolt from inside of the bellhousing, not the outside. That's why it might look like...
Hey Mike, I'm in the middle of doing that myself at the moment. Since my truck is sitting inside my garage I'm a bit shy about using a torch....
Welcome to the forum. It's a great place. Lots of help to be found here. I'm assuming you still have the original transfer case (model 221...
According to the 1963 Chevrolet Truck Shop Manual (Page 6-14) both the 230 and 292 have the same firing order 1-5-3-6-2-4. The cylinders are...
Hey Mark. I replaced mine with a HEI out of a mid 70's Chevy. Don't know if I was just lucky or if any of the Chevy/GMC truck HEI's will work....
Thanks again. It does makes sense. Now all I need is a free weekend (or two or three).:)
THanks for the help. What I was really wanting to know (but didn't ask in my first post) was should I replace the supports first, then patch the...
Need a little advice from some folks who have been there and done that. Getting ready to tackle the floor rust in my 65K10. It's really not too...
I had the same problem with my 65. It turned out that the pointer had lost the counter balance weight. It's on the very bottom of the pointer...
that's the 425 which is basically still the same motor, you can make the oil pan swaps, etc with the older 472/500's. However, the pistons and...
Well, if you're not going to restore it at least you'd be keeping it all GM! If you're talking about the new Caddy motors, that's a...
David, That kind of falls into the catagory of "Everything on the truck works" and "It ran when I parked it." With my truck it was "I just...
Thanks for help David!
thanks, I've got the exterior codes, just trying to verify the interior color. I'm not trying to make it a 100 point truck, but if I'm going to...
My local paint shop isn't having much luck finding the interior color code for my 65 K10. It's got the same beige/silver that they all came with....
Separate names with a comma.
