Yes, but how to remove cylinder without a key. I have no key this is why I want to replace it. Terry
Does anyone know how to remove the ignition lock cylinder from the switch if you don't have a key to turn it to line up the little hole with the...
Thanks Nate, pretty much what I thought, just wanted a second opinion. It just kinda caught me by surprise, that I'd come across something like...
I noticed today as I was working on my engine,( I'm re-gasketing it,pan, rear main, freeze plugs, etc.), that the 1st lifter is a solid lifter the...
I'm replacing all the freeze plugs while I have the engine out & the flywheel off. I am wondering what is the recommended way of installing them...
On my recently acquired 235 a PO removed the front guide pin for the exhaust manifold & tapped the hole & installed a bolt, this was not done to...
I bought & installed a new coil , the one ol chebby recommends (IC64),& put just a bit heavier wire (12 ga.) from "-" side of coil to dist.,...
It's 12 volts. So does it sound like it 's probably the coil?
I found a '60 235, trying to get it running. Timing is right, points & plugs are cleaned & gapped, threw a new condenser in, gave it a shot of...
DZT, This is what I need.
I have a '52 Chevy 3/4 ton, the transmission side of the assembly is a 10 spline with the speedometer drive gear & the shaft side is 10 splines as...
DZT, in pic #3, lower left corner, I see you have a front u-joint/yoke assembly hanging out of the torque tube. How much do you let those go for?...
I'm seeing 2 types of head gaskets for the 235, one is a fiber-faced gasket, the other is a copper-faced sandwiched gasket. Is one better than...
Thanks Bill, I saw the post about "red tags" but as I mentioned 2 of them are generic rebuilds with no tags or ID what so ever. Just though there...
I've got 4 generators. 2 have Delco-Remy tags with only model & ser. #'s, the other 2 are part store remans. with no tags at all, none of them...
Happy New Year to all, Besides the shop manual, does any one have a good detailed link on the disassembly/ assembly of the sm420 transmission?...
Can anybody tell me what year these trucks went from 6 volt to 12 volt? Also, what year they went from generators to alternators?
Thanks Evan & Ron. Terry
Evan, I saw your thread & it got me to wondering why couldn't/shouldn't I do that. I have a 216 to put into my '52 (a runner, got it cheap)but I'm...
Does any one know how to convert a 216 to full pressure oiling & insert type bearings? Or have a link to this info? Would it even be worth while...
Separate names with a comma.
