The last time that I looked at pictures of one of your projects I decided to put my 55.1 on a S 10 chassis.Now I see a 37 chevy coupe which is one...
Nate I have a pair of 53-54 hood spring remover tools.I copied a pair that a friend who was a gm mechanic loaned me after I told him about almost...
heater valve Go to www.southernrods.com.Then go to search and type in 12-6008.Hope this helps.
heater control valve All street rod suppliers carry cable controled inline valves. I have bought them from Southern Rods and Parts. About...
Whats with the running boards? Looking at the first picture it looks like somebody welded some diamond plate on top.Probably to cover some rust...
Take Evan's advise and use panel bond.I wish that I had thought of it.I welded up 54 holes from 1/4'' to 3".You should check out www.fatmat.com,I...
Greg, My 55.1 has them.They are spacers to keep from pulling the windsheild trim down too far and blocking the defrost air from the...
Penetrant In my opinion,Kroil is best,followed by PB Blaster. Even diesel fuel or kerosene mixed with a little motor oil or trans fluid is...
Evan, I thought I would post this to ease your mind.A 55.1 AD has the 5/16 bolt at the bottom of the divider bar.I just did mine.Don't know if...
Iskenderian used to make a cam called E2 that would set a 235 or a 261 on fire.I had one in a 235 with a split manifold and dual carbs back in the...
Ron, I have used 5 or 6 EZ wire harnesses. they are easy to install and have circuits for anything that you will ever need.They have a very good...
I have new door glass,vents and windshield. Green tint and shaded windshield.Steele rubber gasket,new whiskers,wiper,etc.All I need is to make...
Willardgreen As I said before,I've had a couple of A-d's .This one is a real pleasure to drive.Disc brakes ,power steering,tilt wheel and...
Thanks Zig. the truck is a '55 also. It is on a '88 s-10 chassis done with a A-D Engineering kit.I had been thinking about it for a while,then I...
I made mine ouy of a piece of 3/4" wide aluminum.Drill a few holes,sand a little,prime and paint.Took less than a hour.
Has anyone installed one of the one piece fiberglass headliners from Bowtie Bits or Chevys of the 40's ? If so how did it work ?
Flashlight, Check out this # on e-bay motors.#110379593384.This one should work.
Flashlight, The hurst indy shifter has brackets like Evan showed and the one I had the handlecame back over the seat in third.Evan is telling...
3 speed shifter Flashight, I had a floorshifter on a overdrive trans in my 55.1 before [I] did the s-10 chassis swap. It was a hurst indy...
exhaust and tires Greg, the truck looks great. just thought i'd share this with you.back in the early 60's i dumped my exhaust out directly in...
Separate names with a comma.
