Looking for a decent 230 six cylinder for my '63. I'm in the Houston, TX area.
Anyone know (off the top of their head) what size the front wheel bearing dust cap is for a 63 1/2 ton 2WD? One has decided to depart from its'...
I bought some stripper from ACE Hardware (it's in kind of a plain white spray can) that works pretty good. Probably a LOT less expen$ive than...
Keep in mind that (for my 63 at least) the path from the brake light to the rear bulbs goes through the turn signal switch. A bad contact in...
Cabs are the same but the dash panels welded into them were different. Different trim hung on them. So the doors should fit.
Yes. But on the 63 it can go on one of two ways as the groove for the clip is offset to one end. Just worried that if it's offset the wrong way...
Success. Took the tank loose and tipped it up a litte. Then used a long pair of skewers like chopsticks to grab hold of it. One final question,...
Unfortunately the float is brass (non-magnetic) and this one won't work.
Now my sender float is floating. Only problem is that it's no longer attached to the sender. Anyone have any good suggestions on how to fish it out?
The latest: Replaced the sender, float, and gasket. Now the gauge works but with a full tank it only reads 3/4 full. A little more fiddling I...
The fuel gauge on my '63 isn't functioning. It bounces a bit off the bottom peg (on the empty side). Possibilities for this include: Bad...
I need a set of brackets for a 63 as well. Everyone has fleetside brackets, but no one has them for the stepside. What gives?
I placed an order from the on line store. I was given an order number. I looked at the "Check Order Status" on the web site and can't figure out...
Anyone know of a good A/C system? These folks sell a 'system' but it's missing some critical pieces (compressor mount). They say the mount 'must...
I'd like to add some shoulder belts into my '63. Anyone ever do this? Ideas on how to make a clean install without having to drill or cut into...
Separate names with a comma.