what size radio tiers should i buy to fit my original 15/5 rims for 1948 1/2 ton. thanks
swap my my 411 for 355 ring is this this verry difiacolt on torque tube.i will get a overhall manual first.thanks
i whant to use radials and oridginal hub caps on 1948 1/2ton 6 lug. i need tiers and rims. are the original rims adiquit or what other year rims...
i can buy some realy cheap priced tirers.225/75/16.will these fit in my wheel well properly are they to wide? on my 1948 1/2 ton.i was told 15 and...
i asome i have 200000 miles on a old 292 RV runs ok.i change the oil evrey year last year i only went less than 500 miles last year and will only...
the lock nuts that lock the adjusting screws what size are the lock nuts 19/32 did not sell a socket at napa. is there a substute.and whats the...
i am having problems getting the right timing on my 235.i know the procedger intake valve opens closes piston top ded center on the 1 cilynder...
my 1960 235 i see only 1 opening in the middle bottum of the block.and there is 2 brass lines 1 whith a T.i asome the T is shared whith the...
reinstaling trans on1948 1/2 ton 3 speed,there is a gap of1/8 to 1/4 inch gap betwean my trans and bellhousing.put a new clutch kit and new pilot...
my 1960 230 rochester has 2 carb gaskets to chose from the thin original or the thick half inch or more one what should i use. thanks
what are the torque specs on my 1948 1/2 ton presherplate bolts.i have had problems finding this in manuals.i asome 40 ft. lbs. thanks
will the 16 inch 6 lug 1960 rims work on 1948 6 lug hub and cold i use 1948 center caps. thanks
how do i identify 1/2 ton 1955-1962 rearend.beside the 6 lug hub. thanks
i want to swap to a t5 trans,on my 48 1/2 ton/go open driveshaft.get 55-62 carrer or pumpkin. need to fabricate the new driveshaft ,the rear...
can i use my original 3 speed tail shaft,from 1948 1/2 ton,on sm420 trans.and what is the fourth gear input output ratiol. thanks
will sm420 work whith my 1949 1/2 ton torquetube and i may whant to go whith a open drivetrain will it work whith open drivetrain.what was the...
had drivetrain nois when letting out clutch,then whent away.pulled engie to rebuild.noticed sprigs on clutch where grinding into flywheel bolts.i...
trans noise would hapend when i let out clutch,the clutch noise,then whent away.pulled engie to rebuild.noticed sprigs on clutch where grinding...
whant more top end out of 1948 1/2 ton.if i step up the rearend my 3 speed is to high in first gear.could i use t5 trans 5 speed and still use my...
Separate names with a comma.
