I have a spare tire carrier, under bed style from a 53 Chevy truck if anyone needs it.
Found that I may need a longer clutch release bearing...mine is 1 1/4" (86 Astro clutch/pp set) and the shift fork is very near the bellhousing....
Found these recently at our local U pull it.... [IMG] [IMG] [IMG] [IMG] [IMG]
I brought back a 41 F##d when I dropped off the 77 F##d in Fla. Any one have any experience with one of these? Looking for any advice/etc....
So, the other week I was spending the week painting near Aiken, SC. I stopped at the Ditch Pond Heritage Preserve, a Carolina...
I am beginning a 327 swap into a 53 chevy truck. We plan to use the original 3 speed and column shift if possible. It is a shop truck, so we are...
I will be beginning to install a Fatman coilover front end this week in a 50, along with new brake lines and a new master. I will try to cover it...
So, I leave the house at 4:40 for a quick trip to Lowes and to check the progress on the Ford at the body shop. Wife calls 5 min into the trip...
But I spent the last 3 days painting the front doors of a friend's gameroom store. He is moving to a bigger place... [IMG] Based off a...
http://www.ply33.com/repair/tempgauge Found this link on the HAMB.
How to change out the origional ignition lock cylinder..... After I figured it out, I realized that you don't have to remove the ignition switch....
Pertronix install. Really couldn't be simpler. Remove dist. cap..... [ATTACH] Remove condensor and points, pass through wire block... [ATTACH]...
Cab to running board seals.... consist of a retainer and rubber seals. [ATTACH] Spread a little weatherstripping adhesive on both parts and...
Quick tip: to make front marker lights stay on with the headlights, run this jumper between tail lights and front marker lights...The black wire...
Step one, lay on your back and reach under dash to remove the 4- 3/8" nuts from the 4 corners of the guage.....be shure to disconnect the battery,...
Now for the windlace. Not fun. 2 would be helpful on this also. The book says to slide through the center over the door first, but that wasn't...
Headliner.....the dreaded task. 2 people are really needed, though I did it by myself and took pictures. Start by loosening all the screws in the...
Windsheild trim.....Lines up with these holes. [ATTACH] Start with one hole on bottom, one on the side and one on the top. This will hold...
Here goes..... Lay out the rubber, and install the trim in the little groove. Use lots of Windex here. [ATTACH] Now work in the glass...lay the...
Now for the cowl vent. Tape everything first. [ATTACH] Clean off old glue. Now glue in the rubber seal. I found that it all fit nicely after...
Separate names with a comma.
