I got a set of headers and intake from Joe and haven't had any problems.
I'm going to look at it some more today but the set up on the the truck is simple. It has a rod that goes from the gas peddle to the bracket on...
Nothing is rubbing I can touch the gas and it will idle up and stay there but when I tap it it will drop. I like the dual carburetors it feels...
When I had a single carburetor on my truck it would idle fine ever time I would stop. But now I have dual carburetors and when I stop I have to...
I took the truck out for it's first drive yesterday man I forgot how much fun is. So far every thing is going good hope it stay that way.
My brother is getting some car out of the shop so we can get the truck in and get the transmission done today before I have to go to work tonight.
I got the motor back from the shop put it in and started it up so far it's doing good. I ran it for a almost 2 hours and the oil pressure looks...
I pulled the hood the raditor,transmission but left the bell housing on and pulled ever thing off the motor. I have pulled the motor 3 times in...
The one good thing is pulling and setting the motor don't take to much time to do it. It took about 2 hours to pull it out and about 4 hours to...
I called the machine shop yesterday they said the guy that built the motor had to 2 crank shafts for my motor. The main bearings were the same but...
I pulled the oil pan and found that some of the rods I could move up and down by hand so I took off a cap and found a bearing had scratch marks...
The block was cleaned and all the oil passages were checked. They told me to change the oil pump and see if that might fix it.
The first time I think it was the oil pump when I first started it had 30 LB of pressure drove it for about 100 miles then it started to knock and...
I really don't know what to do now. I had the motor rebuilt 6 months ago and after running it the oil pressure went to 0. So I pulled it out to...
Is that cam better then the stock one in the truck and the 261 cam fit a 235 block?
Talked to the shop today and they are going to rebuild the motor again they said they think it was the oil pump so they sent it out to get it...
I called the shop today and they said it looks like the oil pump failed but the bearings and crank have wear marks on them. So they are going to...
After waiting for 6 months to get the motor back in the truck and putting dual carburetors on it and tuned it where it's running good the motor...
I put dual carburetors on my truck and took it to a shop to have them adjusted all the guy did is adjust the air screw and said that they were...
Some times when I hit the foot starter it will turn over for a couple seconds before it stop spinning the motor. But then other times it will spin...
Separate names with a comma.