Christmas is still 3 weeks away for me. Can't wait to be home again.
Also if you do any welding on your truck you must unplug the distributor.
They look alike but I'm almost positive that they are not the same.
I use a Mallory Unilite in my 66. You must use a ballast resistor or you will burn up the optical eye. I bolted mine right under the coil to kind...
Did you push the pin in with a paper clip and then turn the key to the left? Also you can get the ignition switch at a local parts store and...
Sounds like you have a case of sluge in the oil pan. It would be wise to change to pump while the pan is off. Replace the pump fill it with oil...
Try CPP www.classicperform.com
For the motor you will need to relocate all the sensors, heads, intake and everything else on up from there. Also if your going to have to motor...
More than likely they will not fit due to brake caliper clearance. It will especially not fit if they are made of aluminum.
A few years ago in Classic Trucks they did a build called project Old Skool. They installed a one piece glass kit that was supposed to be avalible...
Check your timing and readjust your carb. That is usually the problem with mine when it acts like that. Are you using points style distributor?...
Save yourself a little time and get all three hoses and replace them all at once. Make sure the shoes are on correctly. There is a front and a...
I thought the trim rested on the mounting clips. So my thinking is the holes in the middle don't have to be perfect but just in a straight line....
There is 3 diffrent options for your setup at Summit....
66 Kustom this is a public forum and I must ask that you refrain from using any foul language. My kids could see this and be scarred for life.
The only problem with a rear gear swap is you are going to have to change out the carrier plus the gears. With just the tranny swap I dropped 1400...
Consider a 700R4 swap. That extra gear makes a big diffrence.
First cut the bad part of the rocker and remove the spot welds. I drilled small holes in it to tack it in place. If you need to, trim the...
Not sure on that one.
MAR-K, Brothers and Classic Industries are on the high end and sell the best. Our host also sells quality parts. I have bought patch panels at...
Separate names with a comma.
