I need to mention that if anyone wants to do this mod, I'd drill and tap the angle iron that the recovery tank is mounted to. That tank came from...
Picture is crowded... The tap for inlet to recovery tank is in center of the rubber hose in the vent line. This puts it about 4 inches below the...
Thanks Bill. The transmission install is complete. I just haven't gotten the truck out of the shop yet due to other work being done. If you...
Update on transmission... Still not back on the road as I'm now working on fuel tank recovery system, (on a different thread, "what happened to...
Well, Here are a couple of pictures of the work. The recovery tank is polished stainless steel, and the cab is lined with foil backed...
Ok. This post comments on vacuum to fuel tank.
As far as the vacuum required to pull the gas back from the overflow tank, I was going with your suggestion in this post.
First part. I'm using a type j thermocouple input to my Fluke meter, (it has an automatic conversion to digital temp readout). Pretty good meter...
OK. I have a 3x16 in tank. That gives about 113 cu in of volume, or 62 fl oz. Yesterday I measured the temperature of the gas coming out of...
Hi Wasp. At first look, that looks like it would help but I think it would only reduce the amount of possible spillage by the internal volume of...
It looks like all I need to change is, instead of a tee in the location I showed, cut the vent line and attach the fuel tank side to overflow...
[ATTACH] OK. Here's the "artists rendition" of the basic installation. Will this siphon the level back down to the tap point? I don't think it...
Yep, I'll be using non vented cap. The vent line runs external to the fuel filler up to near the opening. If I tee into the piece of flex in the...
Will the volume of expansion of fuel at a lesser temperature rise be reduced in direct proportion? I'm also unsure what elevation I need to mount...
I had to buy the whole kit, but not the kaboodle. Bill, I 've wiped out your phone #, so give a call when you can, please. (I did not drop phone...
Well, I had some help and pulled tranny. Added a seal on input shaft and put nose flange on. Reinstalled with new clutch, pressure plate and...
Belated Merry Christmas to All here on the forum!
I'm revisiting this issue. No trouble, but it needs to be done. I'm going to measure the fuel temp as it comes from pump, and see what actual...
Made some trips to a couple of the flooded areas last couple of days!! Man, it's heartbreaking to see how many people have to gut their homes and...
[ATTACH] [ATTACH] [ATTACH] Hey Zig! Thanks for the inquiry. I've been keeping a low profile around this site lately. No particular reason, just...
Separate names with a comma.
