my guess is somethings shorting, pull apart the turn signal assembly and look at the connections inside, also is that a tilt column? i have seen...
ill keep my eye out, ive been subscribed to that mag and kar culture deluxe mag since they started them a few years back. your truck is exactly...
if you go plastic just make sure you make a shield that covers the entire bottom and a couple of inches up the sides. plastic is really best for...
no problem, i considered doing the cut and weld swap also but the local company that did that moved to california, so i would have had to ship my...
62 i sent you a private message, you, like myself, want to keep the old school steel wheel. the problem your having is the shape of the rim, steel...
im with you, i only wish the ones that stayed would have evacuated when they had the chance like the others did.
it holds grease in as well. ya, when you install the ball joint, do it with out the boot, then after the joints installed you tap the boot on with...
the ball joints are indeed different per the years you are speaking of. i have worked on several vehicles were when using certian aftermarket...
if your wanting to stay with the origanal vaccume set up and have done all the repairs as above mentioned, you can also add a vaccume booster, i...
no problem, let us know if that works, i may have other ideas for you, ive had to rebuild several carbs in the past and it can get tricky.
you may need to readjust your air fuel mixture screw and idle screw. turn you air/fuel screw until the engine wont idle any higher, turn it back a...
the reason you have a gap is because you need to press them in. the factory used rivets for speed in assembly and for liability reasons. all new...
wow, thanks ash, thats a very nice complimant, im sure your a very lucky man too, excpecially with starting a new family. ;)
this is all very good info, i really appriciate all the comments and discussion. thanks for the info on what cars will work for the front end, im...
aahh, ok i see what your looking for, good luck!!
3/4" or 1" i couldnt remember exactly. its been a year since i did mine. the instructions say when you buy the rez kit.
right on sweet 50, ill be pulling the motor and trans for my 53 out of a 78 camaro, i might as well use the rear end too!!
actually, if there the same as the small blocks, jegs sells the bolt on adaptor for the spin on filter.
sounds like a good match, ive got a 8.75 plymouth rearend i swapped out of my plymouth scamp when i four linked it with a shortened ford 9. i...
with a few basic tools, a 1" drill bit and welder the job is actually quite easy, i did it start to finish in less then three hours. including...
Separate names with a comma.
