**Good info. As said cleaning is always good, when lubing sorry I did not say that. The graphite grease works well I have used it too but with the...
:(:eek: Sorry mixed that up. What about a step side drive shaft that was behind a 400TH should be close the the long 350 trans . How long is the...
New one would be better, but it can work. But the best way is to take the cable off hang them up this may take a day or a week or longer. You will...
Now this is from the 1970 up do this work on the most of the 50/60 trans. Because you might just need a new one, it might be striped a bit or wore...
This is right. If you dad a power glid was it the long case find how long your trans & drive shaft are . Find out if the long 350 and your drive...
I have a heavy foot most of the time 2BBL carb suck gas and wast gas copared to a 4BBL carb as long as you keep on the primary side. You can play...
C-15 stands for GMC 1/2 ton C-10 stands for Chev 1/2 ton K-25 stand for GMC 3/4 ton K-20 stand for Chev 3/4 ton hope this helps Oh BUT the K...
Check the board here they sell parts new not everthing but lots of stuff. They might even have the bumper your looking for. (Classic Parts book or...
Well it depened on how bad you want it, or how nice it drives. what it look like under the hood and in side the truck dash, steering wheel, seat,...
It prettyt much the same as said but just in case put a blanket at the back near the cowl and by the fender just in case you slip. There should be...
sound like you load idle is to low. in park what you idle . When in drive it should idle @ around 550 RPM - 650 RPM as high as 650 RPM - 750 RPM...
The only other thing I can say is take a pic of it. and I bet I try to show the 1975-1987 Hei dist . The housing is basicly the same except for a...
I going to take a stab at it maybe EGR valve or O2 sensor not working right all the time. Time to run scan test see what what.
The fuses or the flasher relay chech there by the box to the place where you pluged in the wireing for the turn single.Then check the light...
I forget now, have not had them sitting beside each other. But I think one is longer in the shaft. So the intake manifold might be off a newer the 87.
If every thing check out good with the first post I would tend to think that the second post would be the one that might be hard to see. If your...
Did you check the glove box to see if it's there or the driver door should be a sticker there in one of those places that has that info. If it's...
I'm not sure 1960 -1966 trucks but is your gear box mounted on the in side of the frame. As the 1973 -1987 gear boxes are mounted on the out side...
Kool thanks there even on the east side too :)
what you mean the blower does not blow air cold or hot . Well could be blower motor, blower motor GROUND, restor on the firewall plug vent door...
Separate names with a comma.
