How about N for... New Hubby :D Tied the knot 3 weeks ago In the real world: Problem manager (computer and network related) In Previous...
Naw, It warnt a Chebby It was the GMC :rolleyes: Gotta love em. I could go on about how they're just about all I've owned and how the G's that...
I know where they are!!! They hang out on the Mighty Mississippi with me. They are heaviest during the wee hours of the night in the middle of...
Spring has sprung Woohoo game on!! spring is here and the thunder is rolling around the track once again. Nuttin like spending the day in the...
250 integrated head Integrated head means that the intake manifold is cast (integrated) to the cylinder head. I beleive they started doing that...
Well, if $55K is too much :o it looks like dynacorn http://www.dynacornclassicbodies.com/about_us.htmlhas a new cab and doors available (or soon...
Got an engine hoist and some angle iron? I move my cab by myself. They're lighter than I expected. I built an H shaped thingamajig out of some...
Thanks for that tip! Even though I don't expect to be ready for them until spring at the earliest, I've been looking for steel spacers without...
My 71 did the same thing, went to a floor shift. Another thing to consider, How are your cab mounts? worn or missing mounts will also put the...
Mine did the same thing, to get satisfactory flares, I set the tubing in the block, placed the anvil and press on the block and then clamped my...
RE: Brake/clutch pedal pivot rod re I'm going from memory here so.... If you push in on the metal disk on the spring end it has a clip if the...
I forgot to add that another factor is your engine and transmission mounts. Depending on the setup of the donor, you may have to move the...
I haven't seen the specs on the AD Eng. kit. Honestly, I wasn't greatly impressed with what I saw for the price. I hope there's more to it than...
Can't offer suggestions for replacement carbs, but if all else fails, take a look at your float adjustment, and needle valve. an inline filter...
Here I am... I'm in the middle of an s-10 swap. It's fun if you like fabrication. I'll warn you about the V8 mounts for the S-10, they are...
It sounds like you and I are on the same page, I'm still in the middle of my frame swap. And, since the boat shot craps on me early this season,...
RE: cab repair tips I had the same problem with mine. Not only was the angle wrong, the curve was too wide. I ended up carefully cutting along...
Didn't see if the fuel guage thing got straightened out or not. If memory serves me correctly, check your wiring between the sending unit and the...
You may also have to turn the rotor shaft by hand counterclockwise as you are wiggling and pulling the distributor out.
[updated:LAST EDITED ON Jun-19-03 AT 02:19 PM (CST)]If I remember correctly, I got mine from a late 70s pickup. You could also look into some...
Separate names with a comma.
