Thanks...I really liked the Olds diesel that I saw earlier this year since I was originally going to stuff a Duramax in mine. I just couldn't get...
I thought I would check to see if anyone else is running alternate power plants in their C-10s, such as Buicks, Cadillacs, Pontiacs, etc. I saw...
So, it sounds like you're familiar with Langdon's. Where are you located? I've hot rodded a few straight sixes in my time, and the last one, I...
Yep, I'm pretty sure you got it right...two-speed switch with a windshield washer function. For my '63, I have a two-speed wiper switch with the...
My buddy used an early model Ford Mustang gas tank that fit between the frame rails of our trucks.
I have an extra '63 C-10 grille, but it is in pristine condition and chromed. Not sure if you are looking for a painted grille for a driver, or...
While my truck is not a 47-54, the process I used can be applied. I traced my patterns onto paper then had them laser cut out of steel plate....
X2...I would opt for a modern fuse block and wiring harness. Do it once and forget about it. Today's kits are really easy to handle and the...
My friend located the filler cap through one of the wood planks like most other rear tank kits. The tough thing about a filler cap and neck...
Be careful with the poly tanks/cells if there is no solid support underneath (i.e., straps, or solid mount, etc.)...it will sag and distort the...
My buddy used a Ford Mustang tank (21 gal.). It fit perfectly between the frame rails - he had the tank between the frame rails before he did the...
I'm with Val on this...you might end up paying the same amount, or more to rebuild the stuff you pull off of a junker - and the parts would still...
:D Oh, I just meant that sometimes, since I'm clumbsy, that the bearing assemblies fall on the ground on me, so I usually have a clean, lint-free...
Is your hub mounted like mine (ignoring the slotted and drilled rotor portion)? If so, there should be a cotter pin, retaining/castle nut and...
It's usually easier to remove the hub (is this for the front or rear axles?), especially if the new stud is too long to access from the back....
You can go with a set of racing wheel studs (I did on my rotors - photo below), which are generally longer so that they protrude passed an open...
I believe the '66 Custom Cabs used the '62-'65 Chevy II/Nova steering wheel - the basic truck steering wheel does look very similar to Chevy II...
That truck has some interesting options that normally didn't make their way onto these trucks. I think my '63 project was in worse condition when...
The crossmember 62 short step noted in the link is the one I'm using. It's the easiest to mount and position. I'm also running a 700R4...
Yep, lots of transmission cross members available. Since you're going with a SBC, the motor mounts are readily available in both tubular form and...
Separate names with a comma.
