I don't waste my time looking for hens teeth so just go to Rock Auto and order a ring and pinion (R&P). There is 3.42 available for the 8.875 R&P...
Need more information. A 292 has the same bell housing bolt pattern that was used from a 153 four cylinder to a 454 big block. Any standard or...
Since it is on one side only you can replace ONE SECTION at a time. Start with the worst one and after it is done do the second but wouldn't cut...
The 54 engine is the best 235 fit. The 58-62 235 is the best engine but takes a water pump relocation kit. Worth it in my opinion and gives...
Short answer---NO. you do not show where you are located but if near north Texas we have several 55-59 pull outs in the rear end scrap pile that...
Here's one for "cantdrivemall". Just because ones abilities are limited to a wax job or new set of tires doesn't mean others lack the skill and...
I hope you know that what you have on the menu is going to run around 20k if you don't have to farm out any work. Once done it will never drive...
We put a Saturn Vue unit on our 1941 Ross forklift but have a Prius to go on my 37 Buick. All need to wait for Russ to do a step by step since his...
Emergency (or parking) brake transfer link. Also known as an equalizer bar. Do a search for " picture of Huck emergency brake " and it will show...
We do this to about 6 or 8 AD trucks a year so a bit more information would help for advise. Are you leaving the straight front axle and drum...
If you ask our host for a free PAPER catalog it has a very good year identification and description on one of the first pages. May do so online...
If you are speaking of the U-joint (not yoke) at the front of the torque tube it is held to the transmission output shaft by a 3/8-24 bolt and a...
I have some pics of the AD-Engineering cab/bed mount that may give you a ball park idea. After using a kit we made a "mule" out of a 52 3100 by...
Jack up and put jack stands under rear end. Take off wheels and brake drums Take cover off back of differential---10 bolts Remove set bolt that...
If you can't pull the front clip in 20 minutes don't apply for a job here. Seriously, for this task it is the only way to go. One thing I would...
There is no rule where a different master cylinder has to be mounted in the factory position. On some with bigger transmissions (automatic) and...
The standard for air shocks for years has been Gabriel Highjackers (? sp). They will raise to the desired position but the ride will be much more...
Nate gave away one of my secrets on power and economy---higher temps. All my street rods have welded aluminum radiators and Vintage or Old Air...
Supposed to go all the way down. If it doesn't the usual problem is that either the metal channel or the felt is out of position. With the window...
The basic frame is the same 47-53 and as Nate mentioned, a few tweaks were done during the seven year run. Shock mounts, spare tire brackets,...
Separate names with a comma.
