Sorry I can't dive too deep into your wiring problems. My diagrams are in Florida and I'm in the Middle East. It sounds like you have a short...
Is one wire for the turn signals and the other for the running lights Yes and yes is the ground provided by mounting the taillight bracket...
Tiny button on the switch. Push and hold then pull the knob. I found it in my manual. It is a life saver.
Check the alternator. Using the ohmmeter setting on a multimeter place on lead on the case of the alternator and the other lead on the terminal...
It will be much easier to swap the cab and bed onto the 4wd frame. While it is apart clean it up and paint it install the motor ect.
I would check the plastic drive gear located in the tail shaft of your transmission. It's a pretty simple fix.
You can go to your local parts store and pruchase a power steering box and pump for your model/year truck. You will have to eat the core charges...
I use a large drill bit. It's not the fastest but it works.
Yes they need to be bled, but first find the reason it leaked out in the first place.
Mallory distributors are very sensitive to any voltage surges. They sell a filter for this problem. A bad voltage regulator fried my module about...
I had a 71' that was patched with a piece of sheet metal and a ton of bondo. The truck had a fresh paint job so it didn't really notice the bondo...
When you are bench bleeding don't push too hard. A nice slow and steady push is the way to go. The same applies to the vaccuum bleader. Don't use...
Try using a vaccuum bleader. Sold at sears. It will allow you to suck the air out. Just have someone add fliud as you go.
Make sure you use the correct type of wrench to get the old line off. A regular box end wrench will round off the corners. Get a good set of...
I think POR-15 makes a product for tanks.
POR 15 sells a chassis paint kit. The paint is self leveling so apply with a brush and it looks good. It will stop all rust. They also sell a...
Well it's a small block. Can't tell if its a 283 or not. If I have to guess I would say no and here is why: 1: it looks like a long water pump. It...
Some indicators that you might have a 283 or an origional motor, is the pressed in oil filler, heat riser for the choke (I think that is what it...
The last thing I would check is the rubber lines. They may look good on the outside but could be swollen shut. This would cause the back brakes to...
I would have to agree with everyone else. Trucks with sun roofs are a no go. The problem with patching it closed is getting all the right curves...
Separate names with a comma.
