check the windowsheid for leaks around the cluster or the Printed Circuit board has got burned some where, Corrosion on the board, dust shorting...
Any one looking for some Big Block Chev Valve Covers??
No. You shoud not have to change the TQ if it bolts attch property to the flex plate.
Jcwhenty use to have them. The last time I picked up a set, but that was 10 years ago at least.
Well first off you will have to go to a (salvage or junk yard) get a 83 or 84 and car or truck 305 or 350 motor up Dist. with the same wire ( 4...
Well to start it will be twice the work.;) It take you time to take apart two trucks drive trains and put one back it. the biggy is the rust and...
Yes you can use older motor. But you have to see what your state law let you do. (E-Testing) But there is a few ways you could do this just bolt...
Truck in Barry Ont 1954 3100pu Engine bay Air cleaner Pic related truck in Barry ONT, 1954 3100 pu Engine bay Air cleaner back in june ,2,06...
I would all so check for the TRICKY Grounds "after years and bump, shaking, rust, air, rain, sand, rocks" they go bad or brake too. All so as said...
As for the TRANS Did You CHANGE the OIL & FILTER When the last time. might be low too, or the bands are starting to wear out.
Well we have C.T. up here. I know how you all feel same here, So for a long time now. You will have to word things so it will trick them in to...
Fit 454, 427, 396, Big BLOCK Chev BBC ValveCovers thick ALUM casting Edelbrock vintage mid 70 to mid 80's ribbed center (has factory bowtie...
That would be a heavy half ton rear set up. :D . Oh the three leaf set up is very very light duty it is 1/4 ton. :cool: So this is not for...
73-80 front clip change to 81-87 Hello there . Well there is a fair mount of work Changing 73-80 to 81-87 front clip .Will take some pic to give...
reply to your ? hope this helps Hello there. How many leaf are on your rear diff. If there is only 3 or 4 leafs then some one taken some off or...
Do you have a 2WD or 4WD. Do you have a 700R4 yet ?. You will Need the down shift cable, if you have a 2WD you will have to move cross member...
.............................................. I have a set of BB 454 Edelbrock covers*forsale*valves .................................... I...
So the Brakes would be 11" or 11"5/32 on the 12 bolt 8"7/8 ring gear 1/2 ton 2WD one or two piece drive shift. The 13" would be the bigger diffs...
Well the 12 bolt 8.7/8 went from 73-81, 81 was the last year for the 12 bolt after was just the 10 bolt 8.1/2. That for the 1/2 P/u's 73-80...
Ok the answer is yes you can get "line" made up @ a hydraulic shop give them the brake line tube end that fits high pressure side at the pump....
Separate names with a comma.
