The front and rear end on the 89 burb is wider than your truck. I think it will work if you use the wheels from the surburban. They have a...
Sounds like you need to get a front end alignment. It can be adjusted with a few shims. There is a possibility that the springs are too tall and...
The air fuel mixture might be too lean up in the mountains.
A 3lb persuader (hammer) should fix it. Might need to pop out the rivets and pull it out before beating it to death.
Just completely unbolt each side and replace the board.
I installed them on my truck and the flashers stopped working. The LED's do not have enough load by themselfs. They usually sell a dummy load...
Before I was in AK I was in Texas. I ran the 2X70 AC (2 windows down at 70 MPH) there for a few years. I didn't have any problems but then again I...
Pull your drums off and see if it turns freely. If not it is your axle. If you have a real hard time getting your drum off then the brake is...
That nail looking thing is just a rivet. You can buy an inexpensive rivet gun just about any where. The long end goes into the gun and the short...
If you use the 1157 style replacement bulbs make sure to use a dummy load or the flasher will not operate properly. There isn't enough amperage to...
Here is this style but they are kind of spendy, http://www.shiny-hiney.com/trucks.html . And as far as which color does what you'll have to look...
A little spit on the end of the bumper and give it a good push and it should go in. You might also try a small flat tip screw driver to ease it in...
Wow someone has done some real magic on that wiring. Sounds like the blinker circuit and the fuel guage sender wire are some how shorted. I would...
I thought it would only go on one way. Make sure you have enough fluid in it when it is warm.
Sounds like you need a new steering box. You can get them at the local parts store and as long as you have a core to turn in they aren't too...
If we all start bugging these guys maybe it will happen. http://dynacorn.com/site/04home/home.html
If only I wasn't in Alaska. I have a automatic colum and I'm interested in a colum out of a floor shift truck. The freight shipping out of here is...
MAR-K was going to sell them but I haven't seen anything lately.
To find out what motor you have find the VIN and run the numbers on a web site. The VIN is stamped on the rear right side of the motor. It might...
It's funny we're still paying for a hurricane 2 years ago. Big oil still can't bounce back? Even after record profits quarter after quarter. I...
Separate names with a comma.
