This would be a difficult job since you are dealing with a inner and outer skin. the inner skin of a 5 window cab is different than a 3 window...
U joints are pretty simple, there shouldn't be any movement when the drive line is in place and tight. If you feel any movement at all it should...
I've had fly wheel bolts come loose and cause a vibration. Also bad u joints can cause a vibration too. Basically anything that rotates you should...
Those are the block of plates that are used with the economy heater. Check with Brian on this site out of Minnesota, he has a lot of parts and can...
Course thread bolts, flat washers and nylock nuts would probably work just fine....
Your conversions have been mis calculated, 3/64=.046875 or just under 47 thousands and 5/64=.078125 or just over 78 thousands. Or in other words...
Nice work but I have 2 concerns though. First the slide adjuster bracket for the power steering pump appears to be a little light. my concern...
Your problem is on pix # 2, the inner lower corner of the left fork is rounded. It looks like what this is doing is not allowing your tranny to...
When you pull the cover off of the shifter box located on the column under the hood, with the shifter in the neutral position the shifter shaft...
That certainly sounds possible. Then all Ben would have to do is switch the linkages probably down at the trans. I didn't think they could be...
Sounds like the engine was swapped. The 305 was a v6, it was big and heavy, lacked power and drank a lot of gas. It's proper use would have been...
Not sure if I understand what you are saying but 1St. and reverse are on the same linkage and second and 3Rd are on the same linkage. On a column...
retraction "oooopsy" My apology's Nate, after re reading your slang I thought you were calling me a whiner not a winner.....Bad Tim :eek: The...
It's gonna be allright Nate, you'll see.... Didn't Johnny Cash "steel" it one piece at a time? Hears a pix of my mother standing in front of...
A fan and clutch combo should work well as long as you have a shroud....Big Tim:cool:
What is the " Redirad " ?
I researched that possibility too and the cost on that conversion was gonna be around 400.00 with shipping. I probably would have done it if it...
It's a Pyle PLR14MPF and yes I had to do very little modification with a Dremel to the dash to make it work.
I've tried a lot of different things but this is what I tried that seems to work the best...I bought this radio off of E Bay. It's name brand is...
Your third gear syncros are worn out....
Separate names with a comma.
