By the time you put the seat in and screw down the sill plates the carpet shouldn't move. 3M makes a contact cement if you are trying to cover the...
I used the 77 chevy rearend on my 61 with the 15x8 truck ralleys. I gained the fender clearance by bending the inner fender edge up then rolling a...
It's true my 261 does get up and run and I have embarrassed a few small blocks but my small block in my 61 is a whole lot faster....Big Tim...
Did somebody say "the right way is to HOP UP a inliner"? :D I never get tired of this lol lol [ATTACH] .......Big Tim :cool:
WOW! you must have some real GIANTS over there!!!:eek:
On all modern day vehicles they don't use a mid mount on the engine tranny combo. Just cut the original cross member out then set your engine and...
Brit, I'm from Jamestown California and my name is Tim. That's why I go by "Big Tim Jamestown" But for some reason I get called everything but...
Thanks Brit, it's been 32 years of fun, 5 different engine combinations, 10 transmissions, and 4 rearends and finally a complete frame and...
Talking As "Jim" Knows ... Thanks NATE, and it's TIM DAMMIT!!!! TIM TIM TIM TIM TIM TIM TIM TIM TIM TIM TIM TIM TIM TIM Say it with me, TIM TIM...
Did somebody say "Hot Rodding a long stroke engine"?...Not only do you get there, but you get there real fast!!!!! [ATTACH] [ATTACH]
Brand new between the frame rails gas tanks for under 200.00 http://www.scribd.com/full/17608177?access_key=key-ikezgqy43h7a9pmdutn Go to this...
When all else fails refer back to Big Tim's original post lol...... Glad you got it fixed.....Big Tim :cool:
Ok here's the trick for broken easyouts, taps and worn out set screws.....Take a cutting torch and heat up the tap, easyout or set screw only...
If it's broke off flush you can try this...... Drill through the center of the stud and try an easyout but before you pound the easyout in to the...
Thanks Bobby for remembering my post, I searched the archives and found it.....Big Tim :cool: I've had really good luck with a mid 70's GM 3/4 ton...
I agree with Nate completely on all issues. I've had my "54" for 32 years now since I was 16 years old, except I think I paid 400.00 for the truck...
I look this up on the internet for you by googleing "How to wire a fuel gauge" There is lot's of Info. that can be found this way I hope this...
Are they the same ohm readings? for example if the gauge is a 0-90 ohm gauge then you need a 0-90 sender. if all the gauge does is read full then...
It depends on a few things. first are you running a small block or a inliner engine? Second if it's a small block, do you have a short or long...
Sounds like you burned up the starter zig, with a properly tuned engine that starter should work just fine because it shouldn't take more than...
Separate names with a comma.
