I don't know what 4 speed transmission pre-48 Chevy trucks used, but the SM-420 that were used in 48 and later have a plug with a square head on...
Not knowing what generator it is or what regulator the Chinese have copied, I'd start with the "operational checks" on this page 1955 - 1959 GMC...
So what is the ID of the hole in the crankshaft that the bushing should go into? And what is the OD of the tip of the tranny input shaft that...
You didn't say what year and unfortunately my books (1955-60 GMC Master Parts Book) only go through the 1st year of 305 engines. But I'd bet your...
I'm assuming your 55 GMC is a 2nd series (looks like a '56) and not a 1st series (looks like a '54). The motor mounts for the 2nd series GMC...
My Dad always said then back off 1/8 turn. Maybe that is for metric fasteners. Seriously, when I need to know torque specs on a bolt that isn't...
In my '52 GMC (I think your Chevy is the same), there are two U-shaped trim pieces. The open ends of the U meet in the middle of the windshield....
"Still has the tits on it!"
Those, the cable that hooks to the bottom part and something to pull the cable.
The calvary has arrived! Thanks Evan.
You are way beyond my knowledge. If I were presented with this problem I would start with identifying the what make, model and year complete the...
No idea of what vehicle your rear axle and brake came from? Can't ask the previous owner or builder?
Anyone know where to get properly fitting brake and clutch pedal rubbers? The ones our host sells ($7 a set) are too small for the rubber to...
I'll also post these pictures of the brake drum, because I think the max diameter of mine is the same as yours. May help to identify the brakes....
... rear brake shoe. I can't see where the cable connects, but when you stomp on the e-brake pedal the "parking brake lever extension" (also...
...across to behind the ... [IMG]
... the stranded cable goes inside the backing plate and into a spring heading ... [IMG]
... the sheath connects to the backing plate (sorry about the fuzzy focus) while .... [IMG]
... enters a sheath being held by this bracket, which I am pretty sure is not stock '52 GMC. This picture was taken upwards from below the truck....
Took some pictures of mine that may help. Mine is a complete 1967 Camaro 10 bolt rear end, brakes and all. It was already installed when I...
Separate names with a comma.
