Thanks Thanks Nate, I knew you probably had some information on this thing. Sorry I don't have any pics of the thing. I thought I might pick it...
Forum Guru's, I've found a transmission tail shaft extension that allows a oil seal to be installed to prevent the trans oil from going into the...
Radiator Cap I don't know about the cars but the trucks use either a "0" or "4" lbs pressure cap i can't remember which but that wouldn't help...
Whoa Brakes Okay guys, lots of info and frome it I realized I had purchased the wrong master cylinder as I don't have disk brakes. I went to...
Wrong Master Cylinder? Okay, I guess I have the wrong master cylinder too!. I have drums all around so I have another problem.:(
Well I installed the CPP bracket for the dual master cylinder and I plumbed the it with the help of a friend. Upon reflection to the instruction...
The Force is with me Just need new batteries for the light saber I guess:D
I'm Looking for a good set of rear barn door hinges for a 49 panel truck. I also need a good clutch throw out arm and maybe a bellhousing.
Well I have the new bracket and MC installed but the heim joint and rod don't line up exactly. The illustrations on the instructions aren't real...
Slam Dunk Thanks everyone for helping out with the Rim. DZT found one and I placed an order so I'm all set for now. I really appreciate eveyone...
Almost a Rim Shot Voler Thanks for chiming in. I think Deadzone Trucking has me covered on this one. If not I can still give Bob a call.
Rim Shot!! Sending a PM for the info - thanks
Rim Shot! RGMJ00, Thanks for the response. It looks like Dead Zone Trucking might have me covered. I'll post back if it doesn't work out....
Rim Shot FarmTruck, thanks for looking. Maybe someday I'll find a match. I appreciate the effort. Thanks Craig
Rim Shot! Thanks Nate, I'll see if I can find the post. I don't know how to put photos on the forum so I linked the original post to the...
I Appreciate the help Like I said anything would be appreciated after several years of looking this is my last go round for this wheel before I...
Buggered up bolts Nate, et al... I did just that. wire brushed em chased the threads put some ospho on the pits and they look pretty good. Found...
Forum Guru's and all interested parties - at least those with a rim stash. I have one rim and need to find a match. The specs are as follows...
Fuzzy Math I can't do fancy math so I got the numbers off a conversion chart and I probably read lthe metric side or somethin. I got the...
Well I need some expert help on getting the front motor mount measurement right on my 235. Figure 20 in the manual shows where to measure the...
Separate names with a comma.
