Got a 40 Packard in to replace factory steering box with a Vega one (works PERFECT) and I immediately noticed how easy it was to get in and out of...
Bill, On my old Buick my a/c was marginal until I plugged every single place where heat could migrate through the firewall/toe board and then...
The last I corresponded with Russ (Ol Chebby) he was starting on a 41 Ford so as enthused as he approaches a project he's probably got a "how to"...
We do all kinds from high point restoration to all out custom show rides but my favorite is the resto rod. When finished you have one with all the...
Hey, If it gets the job done it's a good tool. We are usually putting engines into places never meant for them and found that it they are...
The Camaro/Firebird rears are getting scarce so the Explorer rear is probably going to get a lot of attention. It's a leaf spring rear end with a...
Craig, I'm sure I have some but really not in the parts selling business. Joe, at Dead Zone truck parts probably has some already pulled from...
Not high tech enough to do a drawing but HL switch is very straight forward. Wire from ammeter to "BAT" terminal on switch, head light wire from...
Just to show everyone that jumping in and trying something new will improve with experience. First picture shows my nephews mig welding 6 years...
And a lift bar shot that gives a better perspective. [ATTACH] [ATTACH]
You are a smart fella. To use a one piece you have to take one side of the bed loose so it can be moved out to where the edges of the plywood...
You can see the mount adapter on the side of the block.
Done several of these swaps along with LT's and even one LS7. We have our own mount adapter pattern but you can buy them from a number of...
On a truck that a long time friend wanted to do mostly on his own and did except for the final making the tin smooth he chose to go with a single...
Not everyone is good at smoothing tin or laying on paint but that sure doesn't mean they don't have skills and this guys skill is spelled with a...
No such luck, as I recall Harvey and Jimmy Stewart didn't mind a little libation once in awhile.
We have all been down this road and I must admit that the last time I went over to the lake across the street and tried to walk across it, I sunk....
Thank you for the compliment but they make me follow a rabbit around now and can eat or drink only what he does. I dream of an icy cold one or a...
With the crankshaft and bearings in the block and with the main bearing bolts torqued to spec the end play should idealy be 0.004 to 0.006...
For a tight bend we usually use a Midland Metals #38874 tight radius swivel fitting. If you find a 90* male/female inverted flare fitting that...
Separate names with a comma.
