Finally Andy - I got the the one new 3 way block I needed from Obs Chevy and it worked great. I (brass) wire brushed the old rear blocks seats...
PaPa Larry's helper Here's a couple of my favorite helper (and truck heir apparent). :cool:
Consider Grey Hound? Would you consider putting it on a Grey Hound bus to Spokane, WA? Larry
I'm looking for the linkage from the accelerator pedal to the carb for a 235 IL6. Thanks, Larry
Riding in an AD Zig - ditto - you reminded me that I never got around to thanking 1952Bowtie Bob on our forum for taking me for a ride in...
Cables Nate - It looked like the DPO started to replace the rear end, and fortunately for me (and not Nate) all he got to was hack sawing both of...
:o OK guys I need some advice again. I replaced my entire (Huck) brake system including new lines. I had a few leaks to attend to, I guess I...
Can anyone help me figure out how to wire up the 3 position fan switch, photos attached? It almost looks like the 6v to 12v resistor is in place...
Brake pedal connection From Paul's photos, the GM looks similar to the Chevy, so here's a couple shots of the brake pedal connection from my...
Zig - If you hear and feel clicking and hopping as you turn, the CV joint is likely worn from dirt getting into it from the torn boots. They sell...
I just picked up a NOS dual action fuel pump on eBay. It has 2 vacuum ports - 1 for the wiper motor, but I need advice on what to do with the...
Floating mid support Guys - I liked Russ' recommendation about duct taping across the center bar...however, my '48 mid support is not "floating",...
Andy - Tight and then back off to get a cotter pin across the end. It was easy. The hardest part was getting the old parts out (the grease from...
Looks to me like a '58 or '59 Chevy 4 door wagon - need to see the tail lights to confirm. Larry
Re-build kit Andy - I used the tie rod rebuild kit this weekend. Check out this picture carefully. The upper parts were removed and replaced...
Do it! I saved the Gordon in My Pictures months ago. My dad was a plumber and drove plenty of panels as I was growing up. It would be great to...
You are correct - WA allows vintage plates for classic registrations. I just need to get the truck running and to the state patrol for inspection...
When trying to check the fluid level/condition in the DPO steering box, it looks like it is full of grease. Any suggestions on how best to flush...
Mission accomplished We have brakes! :D Thanks guys for all the coaching and advice. I left a half pint of fluid on the garage floor from some...
Sold Sold 6/26/08
Separate names with a comma.
