Welcome to the forum Crystal. Our host sells a few electric wiper motor kits for our old trucks. I use one in my '52 GMC and am happy with it....
Welcome to the forum. Assuming you stay at or below 45 MPH as you have stated and keep the tires properly inflated I'd say keep the trailer tires...
I don't have a "hand throttle" cable attached to my Carter YF carb. I unhooked the spring that controls closing of choke butterfly to allow me to...
The Christmas Parade here is a big deal every year. Perfect weather this year. Around 60 degrees. A huge turnout, about a mile long with people...
Fredericksburg Texas Christmas parade 2019
With a 28" tire, RPM would drop from 3004 to 2596 at 60 MPH if you changed 4.11 gears to 3.55.
You left out one variable. At what speed?
You need to find a really old generator/starter/alternator shop. One that has been in the same location since at least the 70s. You shouldn't be...
Any stop light switch I've ever seen on these old trucks has just two wires. One connects to the battery (hot all the time, maybe through a fuse)...
I'm a GMC guy, and it has been many decades since I've had a 235 apart, so please verify this with a manual or someone who knows for sure. I...
One plug has 1 exposed male contact (metal showing) and 3 female contacts that are down inside the plastic. It pairs with another plug that is...
Nothing to lol about. I can't figure out how you are going to connect this up, given the different wiring requirements of the bed roll light and...
To quote Hamlet, "there's the rub!" On either side, the roll light has 3 wires, ground, running light and combined turn/brake light while the...
So what are the other three wires in the bundle to be used for and what do you plan to connect them to? My guess (no documentation here) is one...
I'm pretty sure he has a six cylinder engine Evan. The picture in his avatar doesn't have a V on the side of the truck and he didn't correct me...
Rob is very much still around. If you haven't already joined the forum he runs, I'd recommend it to any old GMCer. Try...
Might be a service replacement block. They came from the factory with just the first 3 digits (the engine size) stamped so the installer could...
Should be an engine serial number stamped on the flat surface of the block just towards the rear of the engine near where the distributor goes...
Which wire or wires in the loom (2 and/or 4) do you plan to connect to the white wire in the left bed roll white wire? Which wire or wires in the...
101 is a short bed 1/2 ton GMC. The lack of the number 8 after the 101 says it was born with a six cylinder engine, not a V8. The P is...
Separate names with a comma.
