You might want to check your gas cap to see if it's vented properly too. When it starts running bad, pull the cap off and see if it runs better.
Take the line and the fitting down to the auto parts store and tell them you need a "Farrel" cut the line back to a fresh piece, usually about...
A 3, 4 or 5 speed Trans. from 1955 all the way up in to the 90's will fit your 235 with no problem. they are all the same bolt pattern. Just count...
Are you f#%kin serious?:eek: Dammmm dude you should have never got outa bed! But here's a tip for you....If you have access to a welder, grinder...
Nice pix!!:D Big Tim :cool:
These are some Pix of a long time friends (30 years now) shop in Modesto Ca. In 1947 Twin brothers Willi and Willard Neville built Neville Bros....
Take the top of the cab off of the doner,(cab top with posts and back window) and put it on the original cab. then repair the other problems...Big...
Just patch it, put a headliner over it and fugetaboudit! :D Or better yet stuff the inside with insulation forget about the patch panel and put a...
Thanks Bobby, Unfortunately it's still a work in progress and that's the most updated pix I have. I designed it after the Chevy SSR. The seats...
Hey Zig, check out the part about switching the wires on the coil in my link....Big Tim :cool:
No you can't put a negative ground alternator on a positive ground system but you can convert a positive ground system to negative ground. Follow...
:eek: Sorry Zig, it's a Chevy and an early one at that 47-49, no gas cap in the cab.....:D......Big Tim :cool:
Here's the dash in my "54" and I didn't lose the glove box...,,Big Tim :cool: [ATTACH] [ATTACH]
While I was out behind the house I'm staying at something caught my eye through the slats in the fence. When I looked over this is what I...
If you only have the switch pulled half way out you will only have tail lights and license plate light . Make sure the switch is pulled out all...
On any 12V charging system 14.9 volts would be the maximum amount of voltage you would want. If you can find a Gen. that puts out 14V then you...
Check with Brian out of Minn. He has a lot of parts listed on this site......Big Tim :cool:
The material for the door panels kick panels and the lower door panels is 1/8" masonite. You can get a sheet of it cheep at most hardware stores....
I personally like the Saginaw 3 speed Trans. However high gear is 1:1 and 1:1 is the same no matter how you look at it or no matter what Trans....
Sounds like if you would just drive it like you stole it all your problems would go away. :D
Separate names with a comma.
