60-62 had torsion bar suspension 63-66 had coil over suspension but the steering is the same from 60-66 ....Big Tim :cool:
You might want to check the drums also, if they are too thin it can cause them to get hot and pull. Big Tim :cool:
You're a good sport Zig......lol...Big James from Tim Town :D
Ok I can't take it no more ! I keep lookin at this truck and all I can think of is make sure you wear your big red curly wig , your big red nose...
I agree except for the "54" Jimmy, now that was a nice truck!! Big Tim :D
Hi Volker, looks good! Nice job I hope it runs as good as it looks...Big Tim :cool:
WHATTTTTTTTTTTTTTTTT ????? :eek::eek::eek::)
The clip is mid 70's, 74 and up. The way you can tell is the location of the steering box which is in front of the A arms on this clip, The 67-73...
Sounds like a couple of things could have made your truck diesel when you tried to shut it off. 1 your idle could have been set too fast or 2 your...
It looks like a mid 70's Camaro clip. The front steer makes it a little more difficult to connect the steering to the column. This clip works best...
I have some great advise for disk brakes if you are interested. I have figured out a way to do them for little or nothing...Big Tim :cool:
Thanks Leyland , I'm using a 350 bottom end also and I actually do have a PCV valve on the engine in addition to the draft tube. I put it in the...
I bet it sounds good, I hope the installer didn't ding ya too bad on the $$$$$ Big Tim :cool:
Sounds like something to do with your turn signals. Pull the flasher out of your fuse panel and see if it stops then see if you still have brake...
I have a 58-235 short block with 5000 miles on it. It has .40 forged pistons, shot peened and I beam ground rods with ARP rod bolts, balanced,...
Leland I made the same mistake on my 61 and I knew better but I didn't have the rear bumper on yet so I couldn't really run them out the back. A...
use graphite wheel bearing grease, Pull the insert completely out of the cable housing and start feeding it back in as you add grease to it. don't...
I think I would use the Fentons, they look good and are more efficient than a stock one that has been split. Big Tim :cool:
Did you grease the cable?
2 1/2" pipe is good. It will help the engine breath better and if you choose to pump up the engine you will already have the exhaust to go with...
Separate names with a comma.
