or speedo shops used to carry geared adapters like this Gear Ratio Adapter to speed your Speedometer up +61% | eBay You'll need one rated at...
When the horn button is NOT pushed, it should read battery voltage on the bottom of the horn switch contact to the top of the horn switch contact....
Sorry Martinus, but I just used the one that Deve recommended. I'm guessing the 3 ohm Pertronix coil has an internal resistor (their web site...
Zig couldn't answer the question because he is TAILGATE DEFICIENT!
Unlike modern VIN numbers, serial numbers on your truck do not offer much information on "what the truck came with". H255K037187 decodes like...
No way this is an ignition problem Martinus, as Jr. said the symptoms are the same with the ignition switch on or off.
That eliminates an ignition problem.
Just for fun, try stomping the starter with the key off. If ignition timing is giving you grief, cranking the engine over with no spark should...
I pulled my posting because I heard that Tom's place is NOT shutting down, just having a "sale".
My Dad used to say I could take anything apart. Hopefully, you are better than I am Evan.
Problem with the gauge is they are too big to fit into the ABS plastic piece from Vintage Air that follows the bottom of my dash from the right...
Woulda run better with QJet carbs, given the connection between Allison and GM. Sounds like you had a great day Paul.
Martinus: Deve added the audio track after he recorded the video, therefore no engine noise. Deve: I think I'll get one of those O2 sensor...
Deve: Lambda Sonde is an O2 sensor. Martinus: I considered putting in a wide band O2 sensor to help in tuning a Zenith 228 carb with an...
I have a 3.55:1 rear gear, 1:1 high gear (a granny-low SM420) and 31" tall tires. 70 MPH continuous cruise is about as fast as the fairly stock...
Using an AC 45 as an example, I looked here: Spark plug cross reference
Close, but no cigar Nate. Baking SODA is sodium bicarbonate, a chemical compound with the formula NaHCO3. It is a salt composed of sodium ions...
The factory Pontiac in 55-59 GMCs used a single forward motor mount and side mounts that attached to the bell housing. Later Pontiac engines like...
Are you sure elevator bolts will do the job? Basically they are sort of flat head carriage bolts. Click below for an engineering drawing of one....
Separate names with a comma.
