I have done a lot of work on the red one. We installed engine, radiator, rear end, lots of sorting out, driver's door glass. It just needs a...
Just finished patching up wiring in this 51..... [IMG] [IMG] [IMG] [IMG]
Just revived this 64 Caddy , last on the road in 07... [IMG] [IMG]
Dave carries what most vendors do. I think I had some Soft Seal rubers that were very hard and difficult to install. I don't remember which...
Been visiting the Moonshiner's show locations again?
Take the old one to the hardware store, they should be able to match it up.
See that little hole? There is a roll pin in there. Drive it out. New locks should come with one.
Cut off the roll pan, fix the dash and throw in a bench, that thing would be right!
So far the zombie protection consists of the spiked bumper........I need one of those bed frame grille guards!
I don't recall. Look on Summitracing.com, they can help you find them.
Electro Magnetic Pulse. Happens in a nuclear blast and othertimes, fries electronics.
Mine is box tubing. The wood probably absorbs some vibrations, but I don't know that it matters that much. The 53 was with wood blocks.
http://www.ply33.com/repair/tempgauge Found this link on the HAMB.
If you are refferring to the lower window track at the back of the door, it slides in under a small tab at the top (door sill) on most trucks,...
Yes, that is the way I had my notch. The pumkin would just hit the bed floor when aired out.
I have seen shocks in many different setups from the factory. A shock's main job is just to dampen the spring so the vehicle doesn't bounce....
Properly welded, you can do a 2" notch. You would probably want to make boxing plates about 2' long to cover the inside.
Make shure you have the rubber gasket between the lid and the body.
Go to a welding shop and ask about a 4" pipe drop. Cut it to the width of the frame, then split it in half and you will have 2 c notch pieces....
Let me know......
Separate names with a comma.
