To start the hood anti rattle strip, first get the screw through the rubber, about 1/4" from the end. [ATTACH] Screw into the first hole....
Time for fender welting on the rear fenders. Start by spreading a thin layer of weatherstrip adhesive on the fender lip. [ATTACH] Lay out welt...
Wiper bezels.....Stick the wiper head through the hole.. [ATTACH] Grab it and put on the rubber gasket, use some sealant on both sides to help...
Here we go. Rear window install: MOST IMPORTANT! Tape all surfaces throughout reassembly. This will help stop enevitable scratches. To...
I use a wood block to jack up the rear of the cab, under the floor....just enough to relieve pressure from the mounts. Unbolt the old ones from...
Here is the rebuilt rear body mount.. [IMG] Here is where it goes... [IMG] And installed.... [IMG]
The mounts bolt directly to the floor/frame, just replace the bushings between the shackles.
Everyone carries those. just a felt U channel. Most places carry a door kit that has those, the wipers, vent window rubber , the division bar...
I like to bolt belts through the floor, then through a strip of steel that runs across under the cab through all of the seatbelt holes, at least...
As for the bumps and rattles, you probably need to do a complete weatherstrip exchange to take out the drafts and door/ window rattles. Sweep out...
No rubber, just the rubber between the shackles.
drill it out carefully.
I do not recall how much it was shortened. Position the carb linkage and bell crank, then make the pedal linkage fit. [ATTACH]
It really is simple. Plan it out and install section by section. Take notes on anything custom you do or plan so you can always consult it....
very nice!
540 rat powerglide It is an origional So. Cal car, used to run all over the place in the 70s.
If you like classic gasser drags, here are some videos of my friend Tommy running in Greer, SC last weekend. He is in the "Old Skool Outlaw", I...
I found the orig. at a gas station, have seen them at Stuckey's, Flying J's, etc. I think I bought my newer set from these guys.....I told him...
Done.... [ATTACH] Assemble striker plate, adjust, enjoy easily closing door! [ATTACH] Now go do the other side.
Install for 52-up..... Trique latches for the truck came today. I had both installed in 2 1/2 hours, not including painting. Start by...
Separate names with a comma.
