Wirebrush and clean all you can. Clean with brake cleaner, then I finish up with carb cleaner to get all the residue off. Now use a good spray...
Paint them, just not the bearing races. Or the threads.
Just Mustang geometry. Fatman's kits have big Chrysler corporate balljoints, metric GM calipers and Camaro or Granada rotors, depending on bolt...
Nice truck. With those bags ran with "T" to each axle, you will want to run a thick sway bar front and rear to control body roll and air...
Which is why I went with the Tung oil. I guess everything fails eventually.
Another satisfied customer.......Like I said, one of the best kits on the market. Our shop is now a dealer and an official install shop.
http://abclocal.go.com/kfsn/story?section=news/local&id=8675728
Unless it is not used and kept inside, clearcoat will not hold up. Check my build thread on how I used Tung oil on the 53.
A core support, hood latch panel, hood, grille and fenders are required to make a chevy front end. The holes could be patched up where the grille...
This is Campy, our new Dalmatian. She is 8 weeks old. [IMG] [IMG] The kids are going to love her to death.
That is the 50 I built a while back. It has a Fatman coilover front end, a Nova rear end...we think. Supercharged 350/350t. Full power...
Not that I am aware of. It may be an old restoration, or someone switched up the doors to take advantage of the extra cooling offered by the...
http://www.jalopyjournal.com/forum/showthread.php?t=629357 This guy shortened his...
The 3/4 ton has a half enclosed, half open driveline. This makes it much easier to swap rear axles.
Have the machine shop clean it up, whatever that requires. Also balance the rotating assembly. I usually have them do the assembly to a closed...
The good used ones don't fit either, never did. I haven't tried any repops yet, but they are supposed to be superior in fit due to correct...
Used to WD40 them at car shows back in the day.
I like the long bed, comes in handy. DON'T clip it! It is cheap on the front end, but in the long run cost much time and $ replacing bushings...
The regular cab longbed s10 fits the shortbed. You would have to extend the frame or go to a shortbed to fit your truck. If your frame is in...
When I had that problem, my cab mounts had settled. New rubbers fixed it up.
Separate names with a comma.
