Here's the link to Deve's most excellent site and the how-to for steering wheel repair. I love Deve's site. It also has the valve adjustment...
My truck had an after-market wheel on it when I got it and it was soooo far away from the dash that I could not figure out how I was going to...
Just checked the site. They have a show in Riverhead, New York just a little ways from me in July. Too cool. The kids truck will definately be...
I can fix that!!! Andy
I PM'ed him for you. Andy
Yeah, I know. Looks like I'm registering it as a '54 until I can clear up the '55 VIN number. Could take months and months. Andy
Figured if it came back bad, I'd just use the plate and paper from the parts truck. Local DMV will not do a search for me on the VIN. Prima...
Okay Nate, sounds like a plan. do you have any contact info for New Hampshire title? I tried googling them, but got dead ends. Andy
I believe that was Ken's 50pu that was looking for that part. Andy
My 55.1 came to me just before it went to the crusher without any paperwork, naturally. I have the paperwork (clear title) and the ID plate from...
Good question. Can't wait for the replies to this one. I know the tailgate is the same for some years after, because I have seen it on later...
Cool. Never thought of lowering the truck that way to clear a low ceiling. Great idea. don't know if I would rest it on the drums, though....
Yeah, Dave is right. I bought a used complete mount off a parts truck just so I could see what it looked like as my truck had no engine in it...
General consensus is that the CP window seal is just not a good product. Most guys on this site recommend the Steele Rubber Co. gasket. I have...
8 foot garage ceiling??? Remove grill, radiator and core support. Make your life easy. Otherwise, it is going to be very difficult if not...
Yes Zig, Vintage Air is definately in the plan for this ride. As is the multi-carb setup with Fenton headers and a nice polished engine...
My gutted Old Navy truck had no heater box in it or wiring harness when I got it. The recirculating heater in the parts truck was shot. I picked...
The two bolts that will go through the holes you will drill on the front mount plate are 7/16" X 2 1/2" long. I did this myself on the '58 235 I...
The place to go for the R&P set is "Patrick's". Very pricey. $700.00 including installation kit plus shipping. I have been toying with the idea...
IIRC they are 7/16" regular thread on my '54. They bolt through the cross member and metal sleeves in the rear mounts into the bell housing so it...
Separate names with a comma.
