Our retired friend that we left build his 52 at the shop used several unique methods in bed building. 5x10 plywood is readily available so he used...
Can't say for sure on a GMC but as I remember the jack on a Chevy was a screw type and had a handle that hinged in the middle. The jack was held...
You can have one painted in a fake patina that you would swear is real rust and faded paint. Some even have fake weld beads for supposedly cracked...
Lucky entrants cause it looks like there are trees giving SHADE. Nice selection. The silver truck looks well done and the red with white top 49 or...
What really makes these guys perk up is pictures---lots of pictures. Sandy is in the finishing stages on her 54 Chevy with Hydramatic and it's...
Steve, Don't shell out big bucks for a flip up board kit. We use filler door hinges and electric release solenoids from 80's and early 90's...
Something so obvious I forgot; check the wire inside the distributor that runs to the points. If these wear a bare sport and ground when the...
Did you loosen or pull the fuel line at the carb and crank over? Pull the wire from the + side of the coil so no spark is going on while cranking....
Really coming along---looks great. Don't know if you have access to a tig welder but if you could put the fill tube on left side a motorcycle pop...
DO NOT have your face over carb when testing.
Idles fine and will rev a little bit---wiring is right. Culprit is either fuel supply or coil saturation. Triple check the point gap and if in...
Forgot: CAUTION DO NOT USE AT COMPRESSOR PRESSURE!!! My nephew plugged a hose on that he thought was from a regulator while I was holding the...
You will need to take out one of the bolts at the top of the cover to serve as an air bleed while filling through the vent tube or the lube will...
OK, Bill, understand now. The easiest way would be to use a Sanden 508 with a single wide groove pulley. By far the best price I have found is...
Bill, I know the water pumps are different but not about the pulleys. If you get the pilot hole size, bolt pattern, and depth I probably have a...
Big trucks often had multi groove pulleys for a number of reasons. The most common was for an air brake compressor but have also seen auxillery...
To remove the pump take out the two 3/8 bolts, one on each side. Do not take out the 1/4 bolts as these hold the fuel pump mount plate and only...
Very nice fab job on the mount bracket. Looks like just a rag joint will connect the box shaft to the steering shaft. I wonder if this would clear...
Forgot about the Corvairs and I had a pretty salty one. 327/350hp with a Crown Engineering kit to make it a mid-engine set up. Only radials back...
Looking forward to some photos as right now the 4WD Toyota boxes that are a nice fit are getting hard to find and pricey.
Separate names with a comma.
