It probably would be better to adjust the cross shaft arm position by adjusting the "banana" shaped clevis on the rod going to the front and then...
If you're putting a 1/2T axle up front and want to stay 6 lug you might check out the Colorado/Canyon rear. If going to 5 lug then the early 50's...
Thanks everyone, With the drive gear tooth count (Nate) and tag number (Ken) I should be able to close in on one. I couldn't use one off of...
Next question, there is one on ebay for a 270 GMC with Hydramatic. Anyone know if the 270 and 235 use the same starter? Thanks again; Evan
Having trouble finding a starter or a part/casting/tag number for a 54 Chevy with a Hydramatic. A regular starter, car or truck, has a nose too...
I think the center section will interchange with a 3/4T up through 1972. By 72 there were a number of big blocks with automatics behind them being...
A few things you might check while waiting for your planned IFS. The drag link needs to be parallel with the floor regardless of the rake. Extreme...
Panel fit by the factory is called coachwork and we call it "gapping". It's very slow and time consuming work that adds thousands to a customers...
I don't like to let freon out into the air so I was hooking my 37 Buick up to the freon evacuator when a hose separated and whipped around like a...
Zig, I've always liked the idea of "up high" windows. Lots of natural light and out of reach for unwelcome eyes. In hot weather I guess you could...
I see you are from Texas so can maybe offer a little advice. If you can clean the frame and find the ID number you can look up "bonded titles" in...
The lock on the drivers door is the inside door handle---just turn it the opposite way from what opens the door and it locks it. All these young...
I was digging through some of me junk and came across a cruise set up I made for my 37 Buick when it still had a torque tube (inclosed) driveshaft...
I'd bet your fuse block takes fuses with the two spades. On the old glass tube type fuses they made breakers in various amp ratings that fit right...
The overdrive suggestion is a good one. You would still have a manual shift tranny with the lever sticking up through the floor and you can splice...
Wow, Damon, you must be living right; I found him in the first stack of cards I looked at. Dave Aos Cedar Hill, TX 972-291-4391 29MDLA@tx.rr.com
Martinius, There is a fellow not far from me that has probably more inline six manifolds than just about anybody. He cleans them up and is...
We have been working on a 1941 International pickup which has a 400 sbc and did have a turbo 350 trans which the owner wanted to swap out for a...
An option many overlook is the 200R4 overdrive automatic. It fits in without crossmember hassles and a well built one is good for around 350-400...
I think I would get rid of the fuse block to HEI wire. You can run the original pink ignition switch wire that went to the coil to a relay that...
Separate names with a comma.
