Nate, better than a picture is the drawings and photos on their web site; www.tsmmfg.com Click on driveshaft parking brake and then on pinion...
Muriatic acid is a commercial name for hydrochloric acid. It has many uses since it can be diluted to different strengths for different uses. It...
In this case it was already ruined beyond use as some of the teeth on the gears were corroded completely away and the bearings and shafts pitted...
I had never tried this but we got a 40 Pontiac coupe in that had the worst rust in a transmission that I've ever seen. It was not something that...
If your rear end is some kind of orphan and brake parts are hard to find you can use the pinion mount e-brake sold by TSM Manufacturing in...
If you want to trade in that scruffy old umbrella that's mildewed from being put up wet so many times for a super sized tube of sun block cream I...
When putting a V8 with P/S in an AD many times it gets real crowded where the pump is near the frame rail and plumbing in hoses is a test. March...
Most likely the clutch is good if it wasn't slipping. If you pull it out look to see if the facing material is worn down to the rivets and check...
Oops, I was meant to bevel the outlet hole on the manifold and around the inside of the hole in the flat exhaust flange, not the gasket.
I see posts asking about this and we use a quite simple approach that works well. The factory rod that runs from the foot pedal to the AD tubular...
This may clear up the terminology a bit. The pipe from the cast iron exhaust manifold to the muffler is called an exhaust pipe and the pipe from...
Bill, I had a friend that sent me an abbreviated version of this which was just pictures. It did say that an increase of ONE rpm gave an...
Have done several of these but don't like them. Main problem is the tires stick out past the front fenders about an inch and a half and you can't...
Robert, here are some build pictures but can't find the finished ones. You can see a small area has been cut out and boxed back in on the steering...
Plumbing a sender into the engine should be no problem. If you can't use the original hole by drilling and tapping to the correct pipe thread you...
The 47 used a three speed floor shift trans.
The main difference is the 58 and up no longer used shims on any bearings, just replacement shells like all modern bearings. Not sure but maybe...
As long as your not hauling or pulling heavy loads you will love those gears. Everything is quieter and that 283 will just be loafing at 65.
We took the 400 SBC powered MGB to the great parking lot in the sky today. We needed the engine for another project but first, and after several...
The nut should take a 5/16th's wrench to screw it out of the back of the gauge and will have a tapered end that pinched down on the tube the first...
Separate names with a comma.
