I think he's wanting the spider gears--the two of them, not a 2 speed. If he wasn't so far away he could bring some wrenches and tear into some...
I pulled the engine from my 37 Buick yesterday and unlike a 216/235/261 it doesn't have a coil mounted where you can use the holes for a chain...
OK, it might cost you 42 cents for a stamp to send a drawing. We have a problem with reproduction window felt channels wanting to bend unevenly...
Here's one we put on a 48 with a roll pan. There is a plate welded onto one end of a square tube that fits into the receiver. The license plate...
Do you need a job?
Some of the big trucks had a short nipple in the block with a 45 degree fitting then another nipple into the 45 on one end and an 1/8 pipe...
Going from the fat engine to the skinny one is sure not a quicky. We always fab our own side mounts but I believe they are available now. There...
It is a fact.
A neat trick GM did on my 37 Buick was to coat the inside of the rocker cover with about 1/4" of very dense asphalt like substance plus add a 1/2"...
Beautiful 48, Ken, that's what I drove to Texas from Minnesota in 1963. Mine was a two tone ugly green/gray bottom with a dirty white top. I...
The only difference may be in the length. You could mount the selector box with the lower shaft and splined coupler and then measure the distance...
Does anyone have any experience with seat belts with a pendulum activated locking action? All the ones we have installed have had a centrifugal...
Gee Nate, I thought a farm boy like you would recognize a run of the mill 10,000 hp tractor. It is built for the Outlaw Class and has a place on...
Went down to the clean shop to modify some 9 inch ford axles to a 6 lug chevy pickup pattern and saw the boys have their summer toy almost ready....
The easiest is to use the tie rod with the hydraulic cylinder attached. Early cars like chevy's through 64, the ford granada/monarch, 4wd trucks,...
The rear cross member to bed sides were welded at the factory. The welds range from very decent to really lousy. Some might be explained by a new...
We have done several AD's on S10 frames and so far none have been riveted. It is easy however to cut the weld where the rear "C" channel frame...
Steve, Here is how I train my new beginners. On AD fenders you are basically working with an egg as far as contour goes. After the metal is...
If you end up not liking it I'll buy it from you. Mine broke the needle pointer shaft years ago and after using it for so long, feeler gauges...
A few months back I posted a 37 business coupe that we were building for a customer. It was a bit out of place I guess for a truck forum but a lot...
Separate names with a comma.
