break it down and see what crapped out.
Use a 1/4 inch extension propped on a table or in a vice. Put the top of the rivet on it, then use the rivet set tool on the bottom. Swing...
Not a bearing, it just clamps round the axle. the snuber sits on top, and the u bolts sit in the grooves. This keeps the Ubolts from wearing...
I think those are on top of the axle tube where the u bolts rest on top. It is not a bearing. I believe you can adjust the pinion angle with...
I have to slide my head beside the brake pedal, my left arm around my floor shifter, and my waist just fits the door opening. If I have my cell...
If you have the origional switch, it has a housing with a place for a light. If it has been converted to a switch start, it was probably done...
So, what do you have in it? I may be interested.
The kid is dangerous!
http://www.youtube.com/watch?v=zdqgCfam_3M C'mon, you at least cracked a smile.....
Throw the grommet in a cup of hot water to get nice and flexible. Lube up the temp sender first, consult your thesaurus for alternative colorful...
I use a 1/4 inch ratchet with an extension or 2.
[IMG] Truck with c notch, 235/75 15 tires, airbags.
47-033021 is the part you need. 212 temp for 47-48 chev.
With that setup, why would you not notch it? Even if you aren't trying to ride it super low like mine, the notch will help ride quality by giving...
Now try painting murals with about 10 to 15 3rd graders with wet paintbrushes.....and the attention span of a horney gnat.
and the new rubber bumpers help a bit also.
Lots of people want the perfect gaps like they imagined that these great old cars and trucks had with that great American craftsmanship. The...
http://www.truckandcarshop.com/
You will have to replace the whole temp guage. Truck shop has them for the cheapest I have seen. Be very careful when routing the tube that you...
I have a vette manual cylander, and it uses the origional pedal. If you are mounting it under the truck, the arm should be parallel with the...
Separate names with a comma.
