You should make down to the Charlotte goodguys in October.
My grandmother triped on a rug at work and broke both wrists when she tried to catch herself. It caused her retirement. The challenge with older...
I hinged my blockoff plate and put the digital display for my air ride behind it. I used toggle switches to hold the whole thing in the dash,...
I have installed 3 old air hidden systems from Jim Carter. They work pretty well and go in very esily. They hide behind the speaker grille, so...
One of the terminals is hot. This is where the switch gets power. If there isn't a wire supplying power, the switch won't do anything when you...
http://uk.youtube.com/watch?v=RaeeNhbWsuc Just autocross the truck......
In NC you can run any antique plate without registering them. You just have to have the rel tag in the vehicle with you. In SC you can register...
or connect your light wire to the terminal where the battery supplies power on the switch.
Damn, thats purdy.
Like I said.....it aint no "pretty" hot rod, it works too!
our ammeters will handle 12v. no problem. They measure amps, not volts. Incoming power goes to the terminal on the left, as if you were reading...
For now, a satin clear will slow deterioration down, but will not stop it. You can even spray the whole truck with an automotive clear to...
My friend B.J has lots of them. Dave and I went over there last night....He now has about 14 of the trucks in various stages. I'll pm you his #.
And an IC64 coil from NAPA, it has the internal resistor.
wire brush wheel
He is 38 today, and I have been abusing him all day. He is up here helping to trim out my new home addition. I have to get him back for all the...
Doing what it was meant to do.... Hauling the 53 bed remnants... [IMG] [IMG] 600 sq feet of flooring....$2500 in there...more than I paid...
Remember why we are celebrating, who has gone before us and what they have done. Be shure to take the old truck out today and stretch her legs a...
I had a leaky fitting on my Edelbrock carb. I nearly had it stopped. I backed off the fitting a little to get a good hard seal on it. When I...
Yes, the foot starter works fine with the 6v starter on 12v. Just don't crank for too long without letting it cool down a little. It does make...
Separate names with a comma.
