I don't know much about this setup myself, but the '88 Sub I bought for the drivetrain has one. Haven't really looked at the condition of it, but...
I dont know how the cruise control wire comes off as my truck doesn't have it, but other than that there are no snaprings or anything holding the...
On '84 up trucks, the turn signal lever pulls right out, no screws. It goes into the wiper switch, and where the '73-'83 turn lever screwed in...
Really expensive: http://www.usbodysource.com/ I think it would be cheaper try and find a cheap rust free truck from somewhere like California,...
For a pickup, you might want to look into getting bucket seat brackets from a Burb or crew cab. Not sure if they will just bolt to the '02 seats...
More likely its the flasher relay, its cheap and you dont have to pull anything apart.;-)
Check the driveshaft and u-joints for any play. My truck did that until I replaced the center bearing on the d-shaft, not sure if a k20 would...
RE: H4 headlight conversion...anyon My brother put H4's in his '78 C20 and they're a lot brighter than the lights in mine (Sylvania Xtra-Vision)...
The first place I would check for a vaccuum leak is in the engine compartment. Look for the vac booster and follow the line(s) to the engine and...
If its an auto it's then its a 700r4, th350, or th400. 700r4 has overdrive and the th350 has a square pan with a corner knocked off; otherwise...
I remember seeing a 1 piece window kit for '73-'87 about a year ago when I was looking into redoing my vent windows, cost about $750 for the kit,...
>I have a 82 Sierra High. I want to pull my seat out for >upgrading to a later model. I see the front to bolts but not >the rear. Do I remove...
>do you know where i can find a bench seat for my 83 chevy >silverado Where are you located? I am working on swapping my bench seat for a...
Have you considered going with a Nv4500 (5 speed manual) transmission? Low first gear like the 465 but it also has overdrive, and was offered in...
This pic is the main inner ducting/heater core box as you would see it installed in the truck (floor = firewall). [IMG] The white arrow is the...
The most common problem I've heard is that (for defroster vents) there is a flap inside the ducts that breaks so it will not divert air to the...
How worn are your window seals? Back when my brother drove me to school in his '78 I remember it being really cold. His still doesn't have much...
The easiest way to do this is to find a 4x4 frame and do a body swap. Converting your frame requires fabricating brackets, changing out the...
I'm pretty sure you can use one from '73 to '83, although I think there are some small differences. After '83 the wiper switch was moved to the...
If you remove the lower dash bezel pieces and look directly under the column you will find the delay module. The switch is in the column...
Separate names with a comma.
