Side to side motion in a tilt column means that it's time to rebuild it. You might want to check to see if the rods that operate the ignition...
They attach with velcro strips that are glued onto the dash. If the front of your dash is in good shape (from just above the trim plate and down)...
[updated:LAST EDITED ON Mar-29-05 AT 08:50 PM (CST)]As far as I know, all you really need for the body lift is the disks that go between the...
If you really want to do it, you could get a '87-'91 Burb or Blazer tank and fabricate some mounts at the back between the framerails....
One major factor you should consider is what you will be doing with your truck. If its street driven only and you want something cheap and...
Actually my truck already has the holes for some reason, but my brother's '78 C20 doesn't have the holes for 52". I wonder if 1/2 tons get the...
I'm going to do this swap this summer when I upgrade to 3/4 ton suspension. If you are just replacing them with stock 3/4 ton springs, they won't...
Thanks, I did scrub the panels the way the paint recommended prior to painting and after I saw the spots, but I guess it didn't get it all off....
You can find the diagrams in a Chilton's manual.
I just bought a pair of old door panels so I could upgrade my truck to power windows/door locks. The only problem is that the panels are grey,...
I did my interior with spray paint from an autoparts store, $5 per can. It's not the greatest, but it doesn't look too bad either.
I'm pretty sure your "g8" should be "gc" for General Motors, Chevrolet. GVWR = Gross Vehicle Weight Rating, its about how much the truck weighs...
http://www.73-87.com/7387info/8187vin.htm You may want to recheck your VIN, the first 8 should be a C.
RE: grill solutions for 84 chev wit I know how you feel. Seems like an intact grill is the hardest thing to find in a junkyard. I had spotted...
RE: 1978 suburban, engine and trann >Can you lift the entire body off one and put it on the other? I think this is the best way to do it if...
Your front differential should handle that just fine. Its the u-joints and axle shafts you need to be more careful of. Just dont beat on it too...
What kind of motor/trans combos do you have? To get the trans from the '87 into the '86 you'd have to change the output shaft to hook up the...
The oil sending unit is a small cylinder that should be located up on the intake manifold near the back behind the carb. As far as your rear...
RE: will 81 - 87 front end fit on 7 The holes you need to cut for the hood hinges are going to be 1.5" x 4.5" and should be 31.5" from the...
RE: 78 2x4 put in drive rear end go Before you go tearing apart your rearend, I suggest you take a look at the driveshaft bearing. If you go...
Separate names with a comma.
