RE: will 81 - 87 front end fit on 7 All the mounting points will work for the fenders and core support. The one problem is that you need to cut...
[updated:LAST EDITED ON Jan-16-05 AT 10:38 PM (CST)]>>One more question for yall- >Is it normal for oil pressure to drop almost 50% while...
RE: Front end/Rear end swap (additi A newer axle should just bolt in. As far as the gears, it depends on what you want to do with your truck....
The difference should only be about 3 or 4 hundred rpm higher with 4.11's with stock tires. And by your tire size did you mean the outer...
You can start whereever you want, but if the engine/driveline is all good then the interior would be a good place to start. Just make sure that...
The 350 shouldn't affect your speedometer. The speedo cable comes off the back of the transmission or transfer case if 4wd. If you've changed...
If the throttle is a little sluggish that sounds like it might be the choke, but to make sure its not the oil pressure, wait till your next oil...
RE: Newer leaf springs into an olde I'd check on the length of the spring from eye to eye. I know some newer springs are 63" as opposed to the...
When I installed my 3" lift springs I didn't unbolt the lower A-arms or use a spring compressor, although I still had the engine in the truck....
I'd recommend buying or renting the proper coil spring compressor (cheap ones wont work at all, make sure it's the type that goes up through the...
I'm pretty sure theyre 8 lug. 6 lug would be a 1/2 ton 4WD.
The transmission is probably a th350, which has 3 gears and reverse. Its a fairly good transmission if you need some power, but want to keep some...
Try www.chuckschevytruckpages.com and click on VIN #s. They have a reference for 79-80 VINs
Thanks Brant. The choke was replaced during the rebuild so it should just be a matter of getting it adjusted properly. I'm sure I can figure it...
I had my carb rebuilt recently and now my truck is having trouble in the mornings. The engine runs smoothly until I put it into gear, if I dont...
You should have speedo gears that can be changed based on your rear end gears and tire size. I havent done this to my truck yet so Im not exactly...
RE: 75 gas tank (dont want to blow Actually, Ive heard of a few reports of side impact collisions which resulted in the saddle tank either...
I bought an axle off a '77 Chevy and I need to convert my e-brake to the older style (down either side of the frame). Im looking for pretty much...
There shouldnt be any welds on the steering wheel. There should be 2 bolt holes behind the thin metal plate you need to get to, so if thats whats...
I need to replace the driveshaft bearing on my truck. I know I need to take the driveshaft into a machine shop to get it pressed on, but how do I...
Separate names with a comma.
