These links may help with understanding the 35 degree angle. I'm pretty sure the stock antenna was not mounted on the top of the fender, but...
I had 1977 Chevy 1/2 ton 4x4 wheels on my 57 GMC 1/2 ton (which uses the same hubs and brakes as your '54 Chevy. The knockoffs I found on eBay....
That is not how the original filters were plumbed and I doubt that is how your aftermarket filter should be plumbed. The original was a "bypass"...
Sorry, been away from my computer since last Wednesday when you posted this. Where does the return line from the filter enter the engine? I...
So what was wrong? Stock oil filters are on the passenger's side.
There is supposed to be a small diameter tubing that runs up from a fitting at the front of the block. This picture is a close up of where it...
If you cant find the switch for use with the stomp starter you can use the key start switch and just connect the battery, run and accessory...
I don't have any, but assuming 1/2 ton I can tell you that 55.2 through 59 are the same, Chevy or GMC. I know because I broke two left side...
You didn't specify year, model or transmission, but I'm assuming '57 and 250 from the picture and I'm assuming NOT a HydraMatic. Clipboard01 by...
I don't have a wiring diagram of your setup, but I'll bet your ammeter will only show discharge where it is hooked into the circuit. A very basic...
By grounding the - side of the ammeter you have a lot bigger problem than just with the fuel gauge. The reason the fuel gauge wire burned was...
NO, not to ground. It goes to supply anything that should be measured by the ammeter. In the original wiring diagram (see link above) it feeds...
Separate names with a comma.
