Coilover, it also doesn't hurt that those V8's are using variable valve timing, oxygen sensors, knock sensors, higher compression, and more...
I agree with coilover. I might even go as far as to drive it to the painters, unhook the battery, then remove the guages and push them back into...
RE: Running rich Tom, you are correct, there are a lot of different opinions on how to set the idle mixture. An exhaust gas analyzer would be...
RE: Running rich Tom, when you say the plugs show signs of running rich, what are you seeing? Are they fouling out to where there is a misfire?...
Teacher54, does it look like the roll pan "could" be used with the bumper also? I have been looking at possibly adding a roll pan, just to clean...
RE:Toe-in Question Rick, what is the new tie rod? Do they just want you to flip the install, or is it an aftermarket setup? I am curious because...
I know one of the issues with the sender, was it works basically backwards from the stock one. The mustang unit mounts under the tank. With some...
Nate, I have heard of guys modifying the sender. I tried on mine, and it worked for a while, before breaking. I ended up just using a small guage...
Rick, looking through my shop manual, all it says is to install lock washers, and tighten securely. On mine I did as Nate, I used a long 1/2...
RE: Need Help/Advice - gas tanks - The tank in the picture is mine. It is a tank that is listed for the Mustang. 16 gallons, with drain plug. As...
Apache, I did the power disc conversion on my 1950 3100. It is doable if you have some mechanical skills. The brake lines do need to be modified,...
I agree with Nate. Sounds like the thermostat may have malfunctioned. I would not hesitate to replace it, as they are cheap. Is it possible that...
RE: DISCbrakes on a 50 I am running the stock I beam solid axle. I've upgraded to 4 wheel powers discs, front and rear sway bars, changed to an...
RE: DISCbrakes on a 50 Check out companies like Wheel Vintiques, or Stockton Wheel, they have a bunch of different styles. They can also make...
48er, I agree with the other posts for the most part. I use a mig welder myself. I am using a MillerMatic 135. It is great for general purpose...
RE: Cab Carpet Thanks for the advice guys. I will start doing some checking for what is needed. I think I am going to go with black, as it should...
RE: Desert Trip Sounds like my kind of trip. Glad to hear someone's got the time to enjoy it. I'm slowly getting to the point where I am more...
RE: Looking for a 235 out of any ye Lazy, any luck on finding an engine yet? And what condition do you need? I may know of one that's been...
RE: Vacuum Advance Was a semi pushing you????? Just kidding. That's amazing. Didn't think these old trucks would get that much. Are you running...
RE: Vacuum Advance Just curious, did you check to make sure the advance only worked above idle speeds. It should not be functioning at idle, as...
Separate names with a comma.
