I'm looking for the linkage from the accelerator pedal to the carb for a 235 IL6. Thanks, Larry
:o OK guys I need some advice again. I replaced my entire (Huck) brake system including new lines. I had a few leaks to attend to, I guess I...
Can anyone help me figure out how to wire up the 3 position fan switch, photos attached? It almost looks like the 6v to 12v resistor is in place...
I just picked up a NOS dual action fuel pump on eBay. It has 2 vacuum ports - 1 for the wiper motor, but I need advice on what to do with the...
When trying to check the fluid level/condition in the DPO steering box, it looks like it is full of grease. Any suggestions on how best to flush...
Good rebuildable core, complete from clutch bellhousing to water pump, includes motor mounts. It turns and isn't siezed up. Block ID 3851659. I...
I just got my new parking brake cables installed and seem to have an issue with the foot lever wanting to stay engaged (in the down depressed...
I have a pair of NOS inner wheel ball bearings complete with vinyl race. I won on eBay and replaced my entire front bearings - these are extra....
Have any of you tried to change the knob on the end of an original dashboard cable? I have a couple long original 'C' cables and a 'T' cable that...
Anyone taken out their 3 speed column shift and have the part I'm looking for laying around the shop? My gear shift control upper support...
Does anyone have experience with the "original" color acrylic enamel paint supplied by Jim Carter for exterior and interior AD trucks? It is...
Anyone have any tips for puting these back on? :confused: Larry
This is a pretty cool trip to the past, for those of you who aren't on dial up (sorry Nate). (http://objflicks.com/CarsWeDrove.htm)
Any of you messed with these springs? I can't figure out how/where to install them in the hinge. A picture would be worth a thousand words....
Looks good, but underneath that blue paint......
Any of you (Nate?) come up with a tool to replace the wheel cylinder clamp made to keep the wheel cylinder from expanding during brake shoe...
Well, at long last I have received my new 1/4" steel brake line kit. Has anyone used one of these pre-bent kits before? Do I need to buy...
I'm replacing my brake shoes. Is there any harm in replacing the brake shoe pin retaining "warped washers" with something more conventional?
I'm looking for a standard exhaust manifold for a 235.
Any of you sages have some tips on the best way to safely sling/attach an engine for picking? I have a "cherry picker" and would like to keep the...
Separate names with a comma.
