The rear axle has waited long enough Bill.;)
Roller bearing + seal set on eBay right now for $50 + $6 shipping....
I'm away from my books for another week and a half, so this is from memory and should be validated before use. Using stock ball bearings, your...
Just realize that the adjustment procedure for the roller bearings is much different than the stock ball bearings. Ask me how I know.
Same, no washer.
I don't remember a washer between the pitman arm and drag link on mine Paul.
When I put the Buffalo Enterprises (nice name for a one man shop) disk brake kit on my '57 GMC 20 years ago I left the oil slinger off with no...
Summit Racing lists McLeod offset dowels in 3/8" by 1.25" Summit part number MCL-8707-22, 3/8" by 1" MCL-8707-21 and 3/8" x 3/4" MCL-8707-20. If...
Movement between carb and manifold is bad. Don't fix it with silicon. Take it apart and figure out why it won't tighten up properly. Maybe you...
excerpt from OldGMCtrucks: I took the pump to Commercial Water Pump Builders, 9431 Clay Road, Houston, TX 77080. They had it ready the next...
Where'd you take that picture Nate? Australia?
Zig: STOP. Retrieve the water pump if you can. Read this post over on OldGMCtrucks about me and my water pump.
We try. Maybe it's not our fault. ;);)
Well these trucks are antiques as are many of us that are working on them. :D
a couple of spaces might help, or not
And there are many old Chevy/GMC trucks sitting in the back yards and garages of people who started a clip job or frame swap and never finished.
One reason that you've had so much luck at Autorama might be that the judges realize the amount of high quality work that went into your entries....
Here you go Evan. [IMG]
Dual master cylinder no matter what. It's likely that you could mount it in front of your existing booster unit.
Separate names with a comma.
