>I am 36 and feel the same way, no air for me i have made up >my mind. I think i'm going to lower it with coils, I talked >ot my local front...
To straighten out the wiring, I'd suggest ripping it ALL out and starting from scratch with an 18 Circuit rewire kit. You will waste a lot of...
Good article about clutches in the Aug 05 issue of Classic Trucks. DV
RE: Really need some help on 350 en Camshaft 101 http://www.amotion.com/tech/camselect.html ;) DV
Tom, Stay with the trailing arms. The work required to convert it to leaf springs will not be worth the effort. The trailing arm / spring...
Carrier Bearing ? Do you have a two piece drive shaft ? Could it be that empty keg rolling around in the bed ? DVal
[updated:LAST EDITED ON Jun-02-05 AT 04:47 PM (CST)]The 67-72 rears will fit. They are also about 3/4 inch wider on each side. If you are...
" Could you explain what a Chip Coat is and how it looks? The answer I received from the sand blasters was: "All the snow plow trucks get it...
Notice that their Flip Kit will take the rear down 6 inches and has a C-notch kit included. A bit more work, and a bit more drop. If you drop 6...
Check out BellTech and see if their rear hanger kit will work. http://www.belltechcorp.com/pages/gmc.htm
The whole thing should bolt in. A few bolt holes may need to be drilled and the idler arm will need relocating, but it's very do-able. Dval
Use lowering blocks.
If you can get the entire front crossmember it will be a lot easier. Just swap the whole front crossmember, suspension and all. DV
RE: Converting a Longbed to a Short "Yikes...is all that really much easier than digging up a shortbed frame, swapping it, and putting some short...
RE: Converting a Longbed to a Short Here is an article from Classic Trucks about Project Old School. It's a 60-66 example, but it will give you...
RE: What does the designation "cust The Custom designation is applied to trucks usually outfitted with dress up items, chrome bumpers, windshield...
RE: Trany's shot - time to upgrade. With that kind of hourse power and tourqe in front of it, stay with the TH400. Check out TCI at...
OK. First off omit POR-15 as an option. POR-15 is a "rust encapsulator", which means it's made to go "over" rust. Rust won't be your problem...
Yes I believe so. If you are thinking that a two barrel will be better on gas, think again. It will most likely decrease gas milage. WHY ?...
>I just want to say thank You for feedback. This is a great >forum, I really appreciate sharing your knowledge. > >Thank You >Delrio...
Separate names with a comma.
