Hi Sally. welcome to the forum. The best advice I can give you is to check the wrecking yards. Look at the passenger cars for 6 cyls. Look...
Welcome back Russ !!
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=34208&item=2423843159 Ask the seller if this is a V8 zbar.... Dennis
" First will the clutch and flywheel assembly off my 230 with the granny 4 speed work on the 283 and with the 283 starter. " I think you will...
Leaving the trans in will require that you remove the motor by unbolting the bell housing. On a inline 6 this isn't all that difficult. On the...
>i lifted my granny low 4 speed in my self. corse i also had >the tranny hump out of the way to so i could lift it up from >the top. cowboy...
[updated:LAST EDITED ON Jul-09-03 AT 06:58 PM (CST)]Hi Mike, Try this. Install one side first. Be sure to use a small bead of 3M weather...
[updated:LAST EDITED ON Jul-08-03 AT 04:32 PM (CST)]>My old 230 in my '64 died. I want to replace it with a late >model 283 or 287. Will...
Good Luck Lon !! ( I just wanted to get over the hump to my 375 post... What a blabber mouth ! ) DV
Hi Lon, By more work I mean you will need to run new front brake lines. Get your hands on a "GOOD" flaring tool and practice a few times...
Does the brake pedal go to the floor ? A yes answer to this and everything else looking good suggests that its' the Master Cylinder itself....
General, Well Done !!! Nice work Buddy !! Dennis
>From the book I have, the following:"The rear axle is >identified by >2 letters. These letters are followed by numbers indicating >the...
>would that be true of the 3 speeds? The three speed is fully syncronized. Popping out of gear is a common symptom of a bad syncronizer. Is...
Hi Elvis, The clock was not installed in the dash cluster. From the factory, the dash contained , on the right, a tachometer, and on the left,...
[updated:LAST EDITED ON Jun-25-03 AT 09:46 PM (CST)]Sorry. Syncronizer. It's they are inside the trans and keep the gears "syncronized"....
Keep it up Bill !! Your method is a good one. Start with a budget, develop the plan to do what you want as dictated by the budget. Stick with...
Along with U joints, look at carrier bearing if you are still using a two piece drive shaft. The shifter popping out of gear is usually caused by...
Butch, No... Flew into Balt, rented a POS and drove up. It was a really nice show. Weather cooperated with rain at good times in the evening....
I'll be heading out cross country tomorrow for the GM Nationals at Carlisle PA. Anyone who is planning on going, Ask for me at the ChevyTalk...
Separate names with a comma.
