Hi six two ! What do you mean by the mechanical part? The stuff inside the column ? And, when you said you can't find it, did you mean to...
[updated:LAST EDITED ON Jul-12-02 AT 11:34 AM (CST)]You can take the entire front suspension, crossmember and all, from a 72 to 80's doner...
[updated:LAST EDITED ON Jul-11-02 AT 11:36 AM (CST)]Hi Jaybird, Check this site out. Shows how to rewire (at the headlight switch) a...
Hi Shorty ! Draining battery sounds like a short , , ,Shorty. Tracing it down is tedious but not impossible. BUT,,, as you are...
I find it hard to believe anyone NEEDS a speedometer in Alaska !!!;)
That's the one I was referring to in the post above
>Thanks to both of you. >I was able to get the brake lines off the rear but not the >front. Those were a bit rusted. I am going to just...
David, I'm glad that you made it out of that collision OK. I do disagree with you though. There is no way that 16 gals of highly explosive...
Most definatly, Call DMV. It will go something like this. A letter from your aunt stating that the truck was last registerd by a deceased and...
If your system was dry from sitting, you should look everything over. Check all flex lines front and rear for cracking. Inspect hardlines front...
[updated:LAST EDITED ON Jun-29-02 AT 12:55 PM (CST)]There are other suppliers. Get what you can from our hosts here, They are the best....
Hi Adam, If you use Early Classic it will come out exactly as the stance photos show. Your's may "look" like the photos now, but who knows...
I don't believe the number you found is the block casting number. Look again and check here for the reference....
I just installed the heavy duty sway bar from Early Classic (sorry ChevyDuty) on my 64. I had to drill two holes in each lower control arm. It's...
Cori, The following is copied from another web site; "Normally, when an external to internal alternator conversion is done, the white wire...
I got my master cylinder with the disc brake conversion kit I got from Early Classic. (Sorry Chevy Duty) The power booster was an option and just...
Cris, To answer the question, NO doors are not made for these year trucks. At least not Steel ones. The only recourse we have is the wrecking...
I'm not as familiar with GMCs' as I am with Chevys', but, it should go in fine.
Go with a one piece drive shaft. It will cost you abour $100 or so to have made up.
Yes, you can move them and it is a good modification for those of us using an HEI distributer. You essentially mount the motor mounts by...
Separate names with a comma.
